JL Audio JLINK™ TRX High-Fidelity Audio Transmitter & Receiver Kit Benutzeranleitung

- Bit-Perfect PCM Stereo Digital Wireless Technology (16 bit / 48 kHz)
-  RCA-type input/output connectors compatible with most audio 

equipment

-  Up to 4 JLINK receivers can be paired to each JLINK transmitter 

(additional receivers sold separately)

-  Up to 3 JLINK transmitters can be used concurrently (3 output 

channels to choose from)

-  JLINK receiver includes JLINK port for compatible JL Audio products
-  Low-Power Sleep mode after 30 minutes of inactivity

The transmitter and receiver modules may be situated in any position, 
however their placement should be away from heat generating 
sources, such as amplifier or receiver heat sinks. Also ensure that each 
module’s placement does not interfere with the ventilation of other 
components. 
Although mounting is not necessary, you may use the supplied hook 
& loop fastener tape to affix the modules to a flat surface on a cabinet 
wall, rack or component. If you choose not to mount the modules, 
make sure they are placed on a flat, stable surface to prevent damage 
from falling.

1.  Select the source device that you wish to transmit audio signal from 

and power OFF that device.

2.  Connect the JLINK transmitter’s RCA line inputs to your source 

device’s RCA line outputs.

3.  Plug the smaller end of the AC power adaptor into the transmitter’s 

power jack. Plug the larger end of the AC power adaptor into a 
standard A/C wall outlet.

4.  Using the bottom-mounted switch, select one of three output 

channels to broadcast your audio signal. Note: The transmitter and 
receiver need to be set to the same channel.

1.  Select the device that you wish to send the audio signal to and 

power OFF that device.

2.  Connect the JLINK receiver’s RCA line outputs to your device’s RCA 

line inputs.

3.  Plug the smaller end of the AC power adaptor into the receiver’s 

power jack. Plug the larger end of the AC power adaptor into a 
standard A/C wall outlet.

4.  Set the receiver’s bottom-mounted switch to the same channel as 

the transmitter.

1.  Select the JLINK compatible device that you wish to send the audio 

signal to and power OFF that device.

2.  Set the receiver’s bottom-mounted switch to the same channel as 

the transmitter.

3.  Plug one end of the supplied cable into the JLINK receiver’s JLINK 

port. Plug the other end of the cable into the JLINK port of the 
compatible device. The JLINK receiver will transfer its audio signal 
and receive its power connection directly through this cable. Note: 
When connected in this manner, the JLINK receiver’s AC power 
jack and RCA output connections should NOT be used.