Wet Sounds SD6 Benutzeranleitung

High Level Speaker Input (requires adapter)

Please contact Wet Sounds for information.

Auto Turn On Sense Capability

In auto sense mode when the deck turns on the amp’s microprocessor

will detect the deck’s output and automatically turn on the amp. Most 

systems will utilize a blue remote turn on lead. However if you need 

information on how to activate this feature, please contact Wet Sounds.

Marine Complaint

Rubber gasket covering crossover controls designed to keep moisture 

away. Conformal coated pcb for protection against moisture.  Completely 

sealed design for no water intrusion.

Built In Raised Feet

The sinister amplifiers were designed with integrated raised side feet.  

This gives easy access to pull wire under the amplifier.  This also raises 

the amplifier off the boats panel or carpet allowing air to circulate.

The Sinister amplifiers are designed for 4 AWG Power wire (+12 V) and 

Ground wire (GND). You will need to prepare the wire by remove 5/8” on 

the protective shielding on the power and ground wire. Then take an 

allen tool and back out the screws on the terminal block +12 volt wire 

into the +12V side of the terminal block and then tighten the screw back 

into the terminal block. You will do the same for the Ground wire. Please 

make sure you are using “positive” wire for the +12V.  Also, please make 

sure you are running the ground back to the battery when used in a 

marine application.  (in a car audio application, make sure to ground to 

the chassis as close to the amp as possible). You will also be attaching 

the Remote turn on. Labeled Turn ON” This is usually a blue wire from 

the head unit.  

6

FEATURES

POWER CONNECTIONS

7

Speaker Connections

The Sinister amplifiers are designed with a removable speaker plug.  

These plugs were designed to accommodate larger wire (12 ga) or 

multiple wires.  Please make sure if using smaller gauge wire, you strip 

the wire back fold it over and solder the ends. You can attach the wire to 

the amp with the terminals plugged in by using  a flat head screw driver 

and insert the stripped speaker wire and tighten down.  Or remove the 

speaker plugs from the amp by pulling them out. Attach your wires and re 

insert into the amplifier once mounted.  Making sure to follow the 

markings for + and -.  There is also a silk screened guide for bridging the 

channels

SINISTER SERIES FRONT PLATE

SD2 Front Plate Screen

SD6 Front Plate Screen

SD4 Front Plate Screen