Q-Logic Q-Customs Factory-fit Subwoofer Enclosures Benutzeranleitung

Please read all the safety and installation instructions BEFORE operating
your new subwoofer system.

TM

Hook up the supplied speaker lead to the terminal cup connectors inside
the enclosure. 

(Connect the red lead to the (+) connector, the black to

the (-) connector.)

Connect the speaker lead to the subwoofer and secure to the enclosure
using the supplied #8 x 1” woofer screws.  Make sure the screws are driven
straight and are tight to insure an air tight seal around the woofer.
Predrill a 3/16” hole in each corner of the enclosure about 1/2” from the
edge. (picture A)

Raise both of the lower portions of the rear seat to the vertical position.

Remove and detach the driver and passenger side storage compartment
lids.

Run the speaker leads form the amplifier to the enclosure location.

Set the enclosure into place under the rear driver’s side seat.(Picture B)

Hook up the speaker lead from the amplifier to the terminal cup.

Secure the enclosure by installing the four supplied 2” panhead screws
through the predrill holes made earlier and into the plastic beneath.

The small plastic tray will install over the jack storage area, taller side
forward, and can be secured with screws if so desired.

Lower the seat back down allowing it to

             rest on top of the enclosure.

Supplied Hardware
1 - 12’X24' Polyfill
8 - #8X1" Phillips Panhead Screw
1 - 24" Speaker Lead
4 - #8X2" Phillips Panhead Screw
1 - Passenger Side Tray

Picture A

7/01

1 YEAR LIMITED WARRANTY
Ai Research warrants to the original retail purchaser, this product to be free from defective workmanship and material when used under normal
conditions in accordance with the product’s
printed instructions for a period of one (1) year from date of purchase.  Ai Research agrees to remedy any such defect or to furnish a new part in exchange for the defective one at no charge for
parts or labor.

This warranty is limited to Ai Research products and specifically excludes consequential damage to other associated equipment which may result for any reason from use with this product.  In no event shall
Ai Research be liable for incidental or consequential damages or have any liability with respect to defects other than the obligations set forth above.  Some states do not allow limitations on how long an
implied warranty lasts, and/or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you.  This warranty gives you specific rights and you
may also have other rights which vary from state to state.

This warranty does not cover the following:

• Damages caused by water, neglect, abuse, misuse, improper installation or operation.
• Damages caused by acts of God or nature.
• Damages occurring during shipment of the product to Ai Research for repairs.
• Any product which is modified without consent of Ai Research.

If you need warranty service, take the following steps:
1.  Save your sales receipt for warranty registration and service.
2.  Contact the dealer from whom you bought
Q-Logic.  They will give you instructions for warranty service.
3.  If no dealer is available, call Ai Research for further instructions: (405) 624-6722. You must receive
an RA# before returning any defective parts.

  Ai Research
  2805 E. 6th
  Stillwater,  OK  74074-6513