Biketronics BT1004X Fairing and Wiring Kit Benutzeranleitung
14
t For handlebar radio controls to operate, the 1/8” L-shaped plug on black
cable on the Biketronics module (Step 6) must be firmly plugged in back
of radio. On Sony radios it must be pointed straight up toward windscreen.
If controls are not operating check plug for corrosion. Note: Biketronics
module with Kenwood or JVC uses light blue/yellow wire instead of black
cable.
t Check the radio memory and radio power fuses. Fuses should be 10 amps.
Check your Harley-Davidson
®
shop manual for fuse location. Sony radios also
have a 10 amp fuse located in the back of radio under the black harness plug.
1996 - 1997: Both radio memory and radio power fuses must be changed to
a 10 or 15 amp rating for radio to operate.
t If radio does not turn on, check the OEM radio ground wire located on
clutch side of top triple tree cast iron clamp. This ground wire (black/green
stripe) is attached on top surface with a spade connector that can become
damaged or disconnected.
t Radio sound can be greatly enhanced by the use of tone and equalizer
bands. Consult radio instruction manual to access these functions.
t Addition of separate ground wire between radio chassis and bike frame can
cure erratic handlebar controls or power issues. Radio has bolt hole (metric
M4 x 6 bolt) in rear of unit for ground point.
t If handlebar radio controls start to operate erratically, check for pinched
wires in handlebar control housings. Housings can be loosened (not
removed) to manipulate wires. If the problem still persists call Biketronics
for assistance.
Troubleshooting
t It is unsafe to look at the radio while riding. Familiarize yourself with the
radio controls in your garage. Allow yourself time to normalize working the
radio with hand controls and hearing the results.
t Sony radios emit a beep when control input is given. Keep this feature
enabled until you are acclimated to operating the radio without looking at
the radio face.
IMPORTANT NOTICE