ONKYO TX-RZ820 Benutzeranleitung
14
Step2: Connect the Speakers
Connect 12345678 for a 7.1 channel system. Connect
1234569: for a 5.1.2 channel system. Up to two
powered subwoofers can be connected. The same signal is
output from each of the SUBWOOFER PRE OUT jacks.
1234569: for a 5.1.2 channel system. Up to two
powered subwoofers can be connected. The same signal is
output from each of the SUBWOOFER PRE OUT jacks.
0 You can also connect both 78 and 9:. However, you
can only output audio from one of these at a time. When
both are connected, you can switch which speakers to
prioritize. Press Q on the remote control (P6) and use
"Other" - "Speaker Layout" to switch between surround
back speakers and height speakers.
both are connected, you can switch which speakers to
prioritize. Press Q on the remote control (P6) and use
"Other" - "Speaker Layout" to switch between surround
back speakers and height speakers.
Make sure the exposed wires of the speakers do
not stick out of the speaker terminals when
connecting. If the exposed wires of the speakers
touch the rear panel or the + and – wires touch each
other, the protection circuit will be activated.
not stick out of the speaker terminals when
connecting. If the exposed wires of the speakers
touch the rear panel or the + and – wires touch each
other, the protection circuit will be activated.
> Install
> Playback
1/2˝
(12 mm)
a
b
a Speaker cable, b Subwoofer cable
Setup
0 Settings for the speaker configuration you have
connected need to be made in "1. AccuEQ Room
Calibration" in Initial Setup (P24).
Calibration" in Initial Setup (P24).
0 If any of the connected speakers have an impedance
of 4 Ω or more to less than 6 Ω, after completing
Initial Setup, you need to make some settings in the
Setup menu. Press
Initial Setup, you need to make some settings in the
Setup menu. Press
on the remote controller,
select "2. Speaker" - "Configuration" and set
"Speaker Impedance" to "4ohms".
"Speaker Impedance" to "4ohms".