Atlas Sound Atlas DT12 Benutzeranleitung

1. Using a measuring device, mark off 12.25" from one end of tile.
2. Carefully cut tile on mark using utility knife, drywall saw, or RotoZip

TM

.

3. Remove E.O. box cover (A) on enclosure.
4. Use two wire nuts (included) to attach the red (+) and black (-) leads to the field 

wiring.

5. Set tap selector switch (B) for desired power.
6. Install DT12 into the grid with the unit’s tile support edge facing out from the 

installation location. If the speaker location is not favorable, the tile support 
edge may be moved to the other side of the DT12.

7. Replace the cut section of acoustic tile.

 

Power Settings 25V / 70.7V: .25, .5, 1, 2, 4 watts and 8

ȍ

Frequency Response: 85 Hz - 8 kHz

Sensitivity: 97 dB (1 W / 1 M)

NOTE: Wiring cavity is not intended to be used as a junction box. 
A UL recognized conduit clamp must be used for conduit connections.

 

Installation must comply with all Building  

Codes and NFPA guidelines. 

Installation must adhere to N.E.C. and  

NFPA 70/72 wiring directives  

and comply with all National and  

Local Building Codes.

Input

DT12 

Full Range 

4 Watts @ 70.7V

DT12 

Full Range 

4 Watts @ 70.7V

DT12 

Full Range 

4 Watts @ 70.7V

DT12 

Full Range 

4 Watts @ 70.7V

Typical Parallel Hookup of Full 
Range 70.7 / 100V Speakers 
 
Amplifier 
Typical 120 Watt 70.7V Output 
Tap Wattage Total: 16 Watts

1601 JACK MCKAY BLVD.  

ENNIS, TEXAS 75119  U.S.A.

©2008 Atlas Sound          ATS003230 RevA 8/08

TELEPHONE: (800) 876-

3333

FAX (800) 765-3435

Acoustic Tile