Brandmotion FDMC-1210 Benutzeranleitung

1210 Instructions 6-27-14.docx 

Page 1 of 12 

              

Qi Wireless Charging Module with 

          Full Size Trim to Fit Substrate 

Power Harness with 3 amp Fuse
Full Size Trim to Fit Non Slip Mat 
4 – Flat Head Torx 1/4" Screws 
4 – Flat Head Torx 1/2" Screws 
4 – Flat Head Torx 1” Screws 
4 – Pan Head Torx 3/8” Screws 
These Instructions with Trim Template 
Removable Consumer Product Label 

 

     

Plastic Trim Removal Tool 

T-15 and T-10 Torx Driver 
Phillips Screwdriver (if needed)
7mm, 10mm Socket Drive (if needed) 
Center Punch/Scribe Tool 
Power Drill 
1/8’’, 3/8” and 1/2” Drill Bits 
Scissors 
X-Acto Knife 

Wire Ties 
Soldering Iron & Solder 

(Recommended) 

Tape or Heat Shrink Electrical Tubing 
Multi Meter or 12V test light 
 

•  Work in well ventilated area that is clear of obstructions. 

•  Secure vehicle with tire chucks in both front and rear of tires. 

•  Turn vehicle accessories OFF and ensure ignition key is in OFF position. 

•  Wear safety goggles and snug fitting clothes. 

•  Use tools only for their intended purpose and which are in good repair. 

•  Only perform this task if confidence, skill, and physical ability permit.