Kenwood KMR-D368BT Benutzeranleitung

ENGLISH

31

Source name

Display information

 / 

STANDBY

Source name   (*

2

)   Clock   (back to the beginning)

TUNER

Frequency   (*

2

)   Clock   (back to the beginning)

(For FM Radio Broadcast Data System stations/FM Radio Data 
System stations only)
Station name   (*

2

)   Radio text   Radio text+   Title/Artist   Frequency 

 Clock   (back to the beginning)

CD or USB

(For CD-DA)
Disc name/Artist   (*

2

)   Track title/Artist   Playing time   Clock   

(back to the beginning)

(For MP3/WMA/AAC/WAV/FLAC files)
Track title/Artist   (*

2

)   Album title/artist   Folder name   File name   

Playing time   Clock   (back to the beginning)

iPod USB/
iPod BT or 
ANDROID

When [MODE OFF]/[BROWSE MODE] is selected (  9):
Track title/Artist   (*

2

)   Album title/Artist   Playing time   Clock   

(back to the beginning)

PANDORA/
PANDORA BT

Station name   (*

2

)   Shared/Radio station   Track title   Artist   

Album title   Playing time   Clock   (back to the beginning)

IHEARTRADIO

Station name   (*

2

)   Track title/Artist   Clock   (back to the beginning)

BT AUDIO

Track title/Artist   (*

2

)   Album title/Artist   Playing time   Clock   

(back to the beginning)

AUX

Source name   (*

2

)   Clock   (back to the beginning)

*

1 

Battery and signal strength of the Bluetooth device will be shown if [BATT/SIGNAL] is set 
to [AUTO]. (  17)

*

2 

Only for 

 : Turn off the display information.

•  The unit can only be used with a 12 V DC power supply, negative ground.
•  Disconnect the battery’s negative terminal before wiring and mounting.
•  Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire 

(black) to prevent a short circuit.

•  Insulate unconnected wires with vinyl tape to prevent a short circuit.
•  Be sure to ground this unit to the car’s chassis again after installation.

•  For safety’s sake, leave wiring and mounting to professionals. Consult the car audio dealer.
•  Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during 

and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.

•  Do not connect the 

[ wires of speakers to the car chassis or Ground wire (black), or connect 

them in parallel.

•  Mount the unit at an angle of less than 30º.
•  If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red) 

to the terminal on the vehicle’s fuse box which provides 12 V DC power supply and is turned 
on and off by the ignition key.

•  Keep all cables away from heat dissipate metal parts.
•  After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are 

working properly.

•  If the fuse blows, first make sure the wires are not touching car’s chassis, then replace the old 

fuse with one that has the same rating.

[ terminal of the car 

2  Connect the wires properly.
 

See Wiring connection. (  33, 34)

3  Install the unit to your car.
 

See Installing the unit (in-dash mounting). (  32)

[ terminal of the car battery.

JS_KWD_KDC_X301_KN_EN_6.indd   31

23/8/2016   11:22:50 AM