NAD Masters Series M2 Benutzeranleitung

In case you simply cannot wait to experience the performance of your new 
NAD M2 Direct Digital Amplifier, we provide the following QUICKSTART 
instructions to get you underway.

Please make all the connections to your M2 with the unit unplugged 
from the AC outlet. It is also advisable to power-down or unplug all 
associated components while making or breaking any signal or AC power 
connections.

1  Connect your speakers to the LEFT and RIGHT speaker terminals and 

input sources to the applicable M2 rear panel input sockets.

WARNING 
 

2  Make sure that the OFF/AUTO trigger switch at the M2 rear panel is set 

to OFF.  Connect the AC cord to M2’s AC Mains input and then plug into 
an AC outlet. 

WARNING 
 

3  Set the rear panel POWER switch to the “ON” position.  The Standby LED 

will illuminate amber (standby mode).

4  Press the front panel STANDBY button to turn ON the M2. The Standby 

LED indicator will turn from amber to blue and illuminate the VFD.

5  Press the corresponding front panel input button of your preferred 

source input.

Please save the box and all of the packaging in which your M2 arrived. 
Should you move or otherwise need to transport your M2, this is by far the 
safest container in which to do so. We’ve seen too many otherwise perfect 
components damaged in transit for lack of a proper shipping carton, so 
please: Save that box!

Your NAD M2 should be placed on a firm, level surface. Avoid placing the 
unit in direct sunlight or near sources of heat and damp. Allow adequate 
ventilation. Do not place the unit on a soft surface like a carpet. Do not 
place it in an enclosed position such a bookcase or cabinet that may 
impede the air-flow through the ventilation slots. Make sure the unit is 
switched off before making any connections.

Use high quality leads and sockets for optimum performance and reliability. 
Ensure that leads and sockets are not damaged in any way and all sockets 
are firmly pushed home. For best performance, use quality speaker leads of 
16 gauge (1.5mm) thickness or more. 

Should water get into your NAD M2, shut off the power to the unit and 
remove the plug from the AC socket. Have the unit inspected by a qualified 
service technician before attempting to use it again.