Oppo RMK-UDP203 Benutzeranleitung
Rack Mount Kit Installation Guide
Part Number: RMK-203
Contents: (2) rack mount brackets, (1) rack mount spacer, and (4) side panel screws.
Installation:
1. Remove the 4 screws from the UDP-203
’s left and
right panels. Save the screws for Step 3.
2. Position one bracket to the right side of the player
by aligning its top to the top of the player, as
shown in Figure 1. Secure the bracket to the
player using the side panel screws supplied with
the rack mount kit (Do not use the side panel
screws removed from the player because those
are too short). Install the other bracket to the left
side similarly.
3. Position the rack mount spacer under the front
panel of the player, as shown in Figure 2. Use two
screws saved from Step 1 to secure the spacer at
each end to the left and right brackets.
4. The completed unit should look like Figure 3. It is
ready to be mounted using the screws that came
with your equipment rack.
Caution:
The player needs to fit into a 2U rack space. It is
recommended to leave a blank or ventilated 1U
space below and above the player to allow for
better cooling. The player should not be installed
directly above a heat-generating device such as a
power amplifier or A/V receiver.
Please also check the rack
manufacturer’s
instructions and allow for enough ventilation
(Bottom, Top and Sides).
OPPO Digital Inc.
162 Constitution Dr.
Menlo Park, CA 94025, U.S.A.
www.oppodigital.com
Figure 1
Figure 2
Figure 3