Daviscomms Pte Ltd BU10 Benutzerhandbuch

Step 1:

To insert the battery, slide the

battery under the contact spring

bar as shown and ensure that the

rubber seal is in place.

Step 2:

Click the two housings together until

you hear a snap. Ensure that it is

properly closed in all directions.

Step 1:

Stretch and pull the rubber strap apart

and eject the tag out by pushing it from

the bottom.

Step 2:

W ith a coin, slot it in between the

housing flaps and twist to remove the

battery door.

Step 3:

Use the

pointed

edge of the latch key

and insert it into the slot (as shown in

the figure in Step 3) and lift.

Step 4:

The battery will be lifted out

of its compartment.

To remove the battery

To install the battery

2: Getting Started

2.1 Installing and Removing the Battery on the Wrist Tag (battery’s positive polarity faces upwards)

Step 3:

Align the flange of the tag to the wrist strap’s rubber

groove and slide one side in first. Next, stretch the
rubber strap and slide the other end of the tag into

the other rubber groove.

Page 4