Mobile Expertise Ltd D350V2 Benutzerhandbuch
2
3
Introduction
The me-d200/d350 range is a 1 to 5 Watt radio data
modem, which can be used for data up to 9600 baud rate
(using GMSK module) in stand alone conditions.
modem, which can be used for data up to 9600 baud rate
(using GMSK module) in stand alone conditions.
The me-d200/d350 is housed in a rugged cast-aluminium
box sealed to IEC 529 (IP54) making it suitable for a wide
range of mobile and fi xed applications.
box sealed to IEC 529 (IP54) making it suitable for a wide
range of mobile and fi xed applications.
All me-d200 modem units meet the essential requirements
of the relevant European directives and all me-d350
modems meet relevant US FCC and Canadian regulations.
In order to maintain this compliance the installation and
safety information must be adhered to at all times.
of the relevant European directives and all me-d350
modems meet relevant US FCC and Canadian regulations.
In order to maintain this compliance the installation and
safety information must be adhered to at all times.
The me-d200/d350 modem must only be installed where
unintentional contact cannot be made. The surface of
the device may be hot to touch under certain transmit
conditions. A warning label is permanently displayed as
part of the equipment rating label affi xed to the lid. The
me-d200/d350 is not designed for permanent transmis-
sion. If prolonged transmission periods are used, the
unit will become hot and will require an additional
heatsink to be fi tted.
unintentional contact cannot be made. The surface of
the device may be hot to touch under certain transmit
conditions. A warning label is permanently displayed as
part of the equipment rating label affi xed to the lid. The
me-d200/d350 is not designed for permanent transmis-
sion. If prolonged transmission periods are used, the
unit will become hot and will require an additional
heatsink to be fi tted.
When fi tting the me-d200/d350 into a fi xed installation,
care must be taken in the routing of all cabling such that
the insulation cannot become damaged.
care must be taken in the routing of all cabling such that
the insulation cannot become damaged.
The recommended supply sources for use with the me-
d200/d350 are a standard 12V supply, but is capable of
operating in the range
(9V - 18V).
d200/d350 are a standard 12V supply, but is capable of
operating in the range
(9V - 18V).
●
●
●
Preparing for use
Unpacking and inspection
Unpack the modem and check that you have received the
following items:
following items:
me-d200 or d350 Transceiver
User Guide (this document)
User Guide (this document)
me-d200 diagram
me-d350 diagram:
If any of these items are missing, please contact your
supplier.
supplier.
●
●
e11 034663
35