Instant Care Inc. FS433MH-1 Benutzerhandbuch
FCC ID: X08-FS433MH-1
Fall Sensor – FS433MH-IC
This fall sensor is designed for a user to push the button for help at any time. It can also automatically
alarm by pressing the button.
A. Identifying the Parts
1. Pendant Button
Pressing the Pendant Button for 0.5 sec will activate the Control Panel, causing it to dial an emergency call or alarm (CID event code: 101).
2. LED
3. Lanyard
When wearing the fall sensor, it is recommended to adjust the lanyard
so the fall sensor is resting at the center of the breastplate.
so the fall sensor is resting at the center of the breastplate.
4. Battery Compartment Cover
B. Low Battery Detection and Supervision
Fall sensor features Auto Low Battery detection and Supervision.
When a battery is detected to be below the low battery threshold, fall sensor
will automatically transmit a Low Battery detection & Supervisory code to detect
Low Battery every 24 hours. Once the Control Panel receives the Low Battery
detection & Supervisory code, it will then notify the user accordingly.
will automatically transmit a Low Battery detection & Supervisory code to detect
Low Battery every 24 hours. Once the Control Panel receives the Low Battery
detection & Supervisory code, it will then notify the user accordingly.
C. How to Learn In Fall sensor
Fall sensor has a unique numeric code called “ID code”. The ID code enables the Control Panel to identify the signal is transmitted from the fall
sensor.
1. Put the Control Panel into Device Learning Mode
2. Press the Button on fall sensor, a radio signal will be transmitted to the control panel.
sensor.
1. Put the Control Panel into Device Learning Mode
2. Press the Button on fall sensor, a radio signal will be transmitted to the control panel.
1
Note: fall sensors do not detect 100% of falls. If you are able to do so, you should always press the button if you need help.
LED Off
Standby Mode
3 Red Flashes
Powering On
1 Green Flash
Transmitting with Good Battery
1 Red Flash
Transmitting with Low Battery