Andrew Wireless System M4 Benutzerhandbuch

Installation Instruction

The Remote Unit, Extension Unit or Master Unit has to be

mounted by proffessionel / special trained installer.

1.1.

MECHANICAL INSTALLATION

1.1.1. General

Read the health and safety warnings in section 1.3.

1. Do not install the unit in a way or at a place where the specifications outlined in the

Environmental and Safety Specifications leaflet of the supplier are not met.

2. It is strongly recommended to install the unit vertically.
3. When mounting the Remote Unit, the connector flange with the cables must point to the

ground. A maximum tilt angle of 25° to the horizontal position of the connector flange must be
kept in each mounting direction. If a different installation of the Remote Unit is required,
please contact customer service for further information.

4. It is recommended only to use the mounting hardware delivered by the supplier. If different

mounting hardware is used, the specifications for stationary use of the Remote Unit must not
be exceeded.



Note:

Exceeding the specified load limits may cause the loss of warranty!

5. The unit is considerably heavy. Make sure that a suitable mounting surface is used. Ensure

there is adequate manpower to handle the weight of the system.

6. Due to power dissipation, the Remote Unit may reach a very high temperature. Ensure

sufficient airflow for ventilation. A minimum distance of 300 mm to ceiling, floor, etc. must be
maintained above and below the unit. Also, observe the instructions in the individual mounting
procedures

7. For outdoor installations, the pre-mounted front cover must be installed.

8. For indoor installations where the ambient temperature can reach above 40°C, the cover must

be removed.

9. When connecting and mounting the cables (RF, optical, mains, ...) ensure no water can

penetrate into the unit through these cables.

If any different or additional mounting material is used, ensure that the mounting remains as safe as the
mounting designed by the manufacturer. Ensure that the static and dynamic strengths are adequate for
the environmental conditions of the site. The mounting itself must not vibrate, swing or move in any
way that might cause damage to the Remote Unit.