Globalscale Technologies INC GTIMW302 Benutzerhandbuch

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This 

device may not cause harmful interference, and (2) this device must accept any interference received, including 

interference that may cause undesired operation. 

Changes or modifications not expressly approved by the party responsible for compliance could void the user's 

authority to operate the equipment. 

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, 

if not installed and used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following 

measures: 

-- Reorient or relocate the receiving antenna. 

-- Increase the separation between the equipment and receiver. 

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

-- Consult the dealer or an experienced radio/TV technician for help. 

FCC Radiation Exposure Statement 

The modular can be installed or integrated in mobile or fix devices only. This modular cannot be installed in any 

portable device, for example, USB dongle like transmitters is forbidden. 

This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This 

transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This modular 

must be installed and operated with a minimum distance of 20 cm between the radiator and user body. 

If the FCC identification number is not visible when the module is installed inside another device, then the outside 

of the device into which the module is installed must also display a label referring to the enclosed module. This 

exterior label can use wording such as the following: “Contains Transmitter Module FCC ID: YCJGTIMW302

" 

or "Contains FCC ID: YCJGTIMW302” 

when the module is installed inside another device, the user manual of this device must contain below warning 

statements; 

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference. 

(2) This device must accept any interference received, including interference that may cause undesired operation. 

2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's

authority to operate the equipment. 

This device must be installed and operated with a minimum distance of 20 cm between the radiator and user body.