Checkpoint Systems Inc. NANOGATERF Benutzerhandbuch
www.alphaworld.com
Instructions for the
Nano Gate
NANOGATERF
1. The Nano Gate can be installed on any flat
surface.
2. The Nano Gate triggers 3 Alarm RF devices.
3. The red light indicates good battery life and
3. The red light indicates good battery life and
serves as a visual deterrent.
NOTE: Battery life lasts 3 weeks if
operating 24/7
4. The Nano Gate can pivot side-to-side if
bumped into.
5. The Nano Gate will alarm if the Switch comes
off the wall.
6. The Nano Gate should
not be placed within 3
ft. (.91 m) of EAS systems
FACTS ABOUT THE NANO GATE:
• (1) Nano Gate - RF
• (1) Mounting Template
• (2) Brackets
• (6) D-size Batteries
• (10) Metal Screws
• (2) Caps
• (1) Power Supply Cord - 10’ (3.05 m) L
• (1) Mounting Template
• (2) Brackets
• (6) D-size Batteries
• (10) Metal Screws
• (2) Caps
• (1) Power Supply Cord - 10’ (3.05 m) L
NOTE: Electric Hand Drill required but
not supplied
TOOLS SUPPLIED:
PC0277
Pivoting Antenna
Clear
Antenna
LED
Pressure Switch
Annunciator
Powers from
Top or Bottom
1. Insert 6, D-size batteries into the Nano Gate (reference battery orientation in plastic housing).
2. Place the provided Mounting Template onto a flat surface with tape. The Mounting Template will be marked with
TOP and BOTTOM for accurate placement and provides where the holes need to be drilled.
NOTE: Must mount Nano Gate at least 3 feet (0.91 m) from floor
3. Drill 6 holes as indicated on the template.
(Fig. 1)
4. Remove the template. You should have 3 holes on top and 3 holes on bottom.
5. Screw bottom bracket in place with 3 screws.
(Fig. 2)
6. Of the three pre-drilled holes on the top, screw the lower screw into the surface using the “U” on the bracket as
a guide for spacing. Do not tighten the screw down.
(Fig. 3)
7. Insert the bottom end into the bottom Bracket and drop the Gate into place.
(Fig. 4)
8. Place the Gate into pre-drilled screw on top and finish by screwing in the 2 remaining screws into the top
bracket.
(Fig. 5)
9. Place the Caps on both top and bottom ends of the Nano Gate and screw in with the 2 provided screws.
(Fig. 7)
10. Nano Gate is now secure and ready for use.
NOTE: 6’ (1.83 m) coverage requires mounting Nano Gate in off-set locations on the door. (See Diagram 1)
MOUNTING INSTRUCTIONS:
Battery Powered Installation
Battery Powered Installation
6’
Diagram 1
3.5’
3’
Pivoting Antenna
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
FCC ID: YWZ-NANOGATERF IC: 3356F-NANOGATERF