LaserLine Manufacturing Inc 40105 Benutzerhandbuch
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1) this device may not cause any harmful interference, and
2) this device must accept any interference received, includng interference that may cause undesired operation.
2) this device must accept any interference received, includng interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
The antenna connector is designed to fit the supplied antenna. Do not modify the antenna or connect any other type of
antenna. If a replacement antenna is required, contact your dealer for an authorized antenna.
antenna. If a replacement antenna is required, contact your dealer for an authorized antenna.
Any changes or modifications not expressly approved by the party responsible for compliance could cause the module to
cease to comply with Part 15 of the FCC Rules, and thus void the user's authority to operate the equipment.
cease to comply with Part 15 of the FCC Rules, and thus void the user's authority to operate the equipment.
LaserLine LineLokr Laser Detector and Remote Control
Preliminary User's Manual
How to remotely move the Quadrant laser:
Clamp or position the LineLokr on the baseline.
Press Power/Capture
Clamp or position the LineLokr on the baseline.
Press Power/Capture
to align the Quadrant laser to the LineLokr.
Hold Power/Capture for two seconds to turn off.
Contains Transmitter Module FCC ID: ZNS40105 -or- Contains FCC ID: ZNS40105
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
A label is affixed to the outside of the LineLokr that reads: