Xerox 003R06709 Benutzerhandbuch

Seite von 100
Application Ideas and Procedures
Xerox Wide Format Supplies Applications Guide 
Version 2.0; April 2005
79
8.11 Removal Instructions
Substrate surface (e.g. painted vs. unpainted) will combine to make each removal slightly different. The purpose of
these instructions is to provide a general removal method useful in many situations. Always test a small area 
prior to decal removal to ensure that the substrate will not be damaged.
Tools 
• Weed burner/heat gun, razor knife, putty knife, cleaning solvent.
Precautions 
• Follow all instructions and safety warnings when using solvents and chemicals.
Cold Pull
Method
• With a weed burner, heat entire decal by holding heat source approximately 6 to 12 inches away from surface. After heating
entire decal for approximately 30–60 seconds, loosen a corner of the decal and pull back slowly
• A slow, steady pulling and lifting action at less than a 90° angle will usually prevent vinyl from breaking and will remove most of
the adhesive from the substrate. If decal becomes hard to pull, stop, reheat decal, and proceed.
• NOTE: Adhesive residue may be removed by wiping with a clean saturated rag of XXL1000 decal remover, heptane, Xylene,
and/or mixture of 75% MEK/25% Toluene.
Chemical
Method
• XXL1000 decal remover is recommended. It is an environmentally safe, non-toxic, non-flammable decal remover that will 
minimize the time required for removal. Instructions for XXL1000 decal remover are:
• Apply with spray dispenser. Wait 10–15 minutes until vinyl begins to bubble. Peel vinyl from surface.
• If vinyl doesn’t remove easily, a hot water pressure washer can be used.
• If adhesive remains, apply XXL000 again and wait 3–5 minutes before repeating pressure wash.
8.10 Professional Installation
The above information provides basic information on how to apply vinyl graphics. The instructions are designed to
help ensure success across a broad range of applications. Depending on the size and complexity of applications, a 
certain amount of expertise is needed. 
Professional installers can be hired to ensure proper application of finished graphics.