Franklin Wireless Corp NXG9230 Benutzerhandbuch

 

2

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

 

conditions: (1) this device may not cause harmful interference, and (2) this device must

 

accept any interference received, including interference that may cause undesired operation.

 

  

FCC ID: RB2NXG9230

 

  

 

Modifications not expressly approved by this company could void the user's authority to

 

operate the equipment.

 

  

 

NOTE: This equipment has been tested and found to comply with the limits for a Class B

 

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

 

reasonable protection against harmful interference in a residential installation. This equipment

 

generates, uses and can radiate radio frequency energy and, if not installed and used in

 

accordance with the instructions, may cause harmful interference to radio communications.

 

However, there is no guarantee that interference will not occur in a particular installation. If

 

this equipment does cause harmful interference to radio or television reception, which can be

 

determined by turning the equipment off and on, the user is encouraged to try to correct the

 

interference by one or more of the following measures:

 

. Reorient or relocate the receiving antenna.

 

. Increase the separation between the equipment and receiver.

 

. Connect the equipment into an outlet on a circuit different from that to which the receiver is

 

connected.

 

. Consult the dealer or an experienced radio/TV technician for help.

 

  

 

Tests for SAR are conducted using standard operating positions specified by the FCC with

 

the phone transmitting at its highest certified power level in all tested frequency bands.

 

Although the SAR is determined at the highest certified power level, the actual SAR level of

 

the phone while operation can be well below the maximum value. This is because the phone

 

is designed to operate at multiple power levels so as to use only the power required to reach

 

the network. In general, the closer you are to a wireless base station antenna, the lower the