Viagrow Fertilizers Inc. BINBUDDYVF1 Benutzerhandbuch

To use your Bin Buddy, simply place into your bin, making sure not to set the

auger on the sensor.  Insert the auger to the desired depth, or until the
reflective tape is just visible in the bin lid.  Fill the bin and for the first couple of

bins you will want to watch and make sure that the spout is at the right height
so as not to run the bin over or plug the auger.  When you hear the horn, simply
close the gate on the truck, lift the auger slightly and idle down the tractor until

the auger is empty and ready to move.  When inserting the auger in the bin,

make sure the spout is touching the edge of the bin lid opening towards the
tractor.

Remove the batteries when not using the sensor for long periods of time.  We

recommend removing the sensor once you are done with it for the season.

There are no user serviceable parts inside other than the batteries.  Please do

not tamper with anything inside the tube!

“This device has been designed to operate with an antenna having a maximum

gain of 2.7 dBd.
Antennas having a higher gain is strictly prohibited per regulations of Industry

Canada.  The required antenna impedance is 50 ohms.”

“To reduce potential radio interference to other users, the antenna type and its

gain should be chosen that the equivalent isotropically radiated power (EIRP) is
not more than that required for successful communication.”

Operation is subject to the following two conditions: (1) this device may not

cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
FCC

IC Canada

WARNING:  The use of external RF amplifiers with low power devices is strictly

prohibited.