Hanna Products MAIL-1200 Benutzerhandbuch
Mail Chime
page 1
Patent Pending
How It Works
When the mailbox door is opened, the Receiver in the house will buzz
four times and display a red LED light. Press the reset button to reset.
four times and display a red LED light. Press the reset button to reset.
Model 1200
User's Manual
This device complies with Part 15 of the FCC rules. Operation of this device is subject to the following conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the
party responsible could void the user's authority to operate this equipment.
To comply with the FCC RF exposure compliance requirements, this device and its antenna must not be co-located or
operating to conjunction with any other antenna or transmitter.
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the
party responsible could void the user's authority to operate this equipment.
To comply with the FCC RF exposure compliance requirements, this device and its antenna must not be co-located or
operating to conjunction with any other antenna or transmitter.
FCC ID: RNCMAIL-1200
Hanna Products Inc.
Made in China
2602 37th Street, Rock Island, IL 61201
Phone (309) 788-1982 www.hannaproducts@mchsi.com
Phone (309) 788-1982 www.hannaproducts@mchsi.com
tm
Designed in USA
Remove top case by removing four screws.
Slot Type
Curb Side
Reassemble the case using the 4 screws.
Hold down on battery and pull plastic strip from battery holder.
Set dial on # 4 - Mount with arrows on Sensor
pointing up towards the top of the mailbox door.
pointing up towards the top of the mailbox door.
1
2
3
4
Wall Mounted
4
3
2
1
1
2
3
4
Refer to page 2 and set the dial setting for your type of mailbox.
double faced tape
1.
2.
3.
4.
bat
ter
y
+
-
Set dial on # 2 - for mailboxes with short tapered lids and flat tops
Set dial on # 3 - for mailboxes with large tapered lids.
1
2
3
4
1
2
3
4
Set dial on # 4 - Mount with arrows
on Sensor pointing up towards hinge.
on Sensor pointing up towards hinge.
Mount with arrows on Sensor pointing up.
Mount with arrows on Sensor pointing up.
1
2
3
4
Receiver
Hanna Products Inc.
Reset
Mail Chime
Package Contents
AC adaptor
tm
Sensor
12 volt, A23 battery ( included)
1
2
3
4
Battery can be purchased
at most drug stores and
"battery specialty" stores.
at most drug stores and
"battery specialty" stores.
Trouble shooting
1. Check if you mounted the Sensor correctly on your mailbox.
3. Try moving the Receiver to a new location in your home.
2. Check if the battery is installed correctly.
4. Please call 309-788-1982 for any questions
1
2
3
4
Plug the AC adaptor into the back of the Receiver and then into
the wall outlet. The Receiver will beep two times. The red LED
bulb will not light until the Sensor sends a signal.
the wall outlet. The Receiver will beep two times. The red LED
bulb will not light until the Sensor sends a signal.
Straighten the antenna vertically.
Receiver
AC Adaptor
6.
7.
page 2
Peel the protective cover off the double faced tape on the
bottom of the Sensor and attach the Sensor to your mailbox.
bottom of the Sensor and attach the Sensor to your mailbox.
5.