G.pulse Int'l Co. Ltd. HRM300 Benutzerhandbuch

 

 

@@ Heart Rate Transmitter 

@@ Textile Elastic Strap 

@@ Battery Cover 

@@ O-ring 

@@ CR2032 3V Lithium Battery 

Step 1. Slightly moisten electrode area with some water on the textile strap.(If 

necessary) 

Step 2.  Attach the Bluetooth smart transmitter to the textile strap 2 

connection buttons.  

The right metal button should on the right side, and left to 

left side of the body.

 

Step 3.  Adjust strap length and wrap around chest. Insert clasp to loop end. 

Make sure strap is fastened on your body properly. 

Step 4.  Make sure the electrodes are pressed firmly against your skin. The 

sensor should be centered on your chest in the upright position. Led light 

should be on the top side. 

Step 5.  You can check the transmission success by red led flash light, it ‘ll 

continue flashing 5 minutes when detect active pulse. After this period, it’ll 

enter power saving condition-no flash. 

Step 6.. NFC function: The smartphone can start the relevant tracking 

application or connect to the website  just by touching the transmitter.   

1. Use water, ECG gel to other conductive liquids to moisten the conductive 

rubber skin contact. 

2. Do not use Vaseline or Oils which may insulate the Transmitter making it 

unable to detect the heart rate signals. 

3. To save the power, if you don’t want to detect heart rate, pls make sure to 

take off  the chest belt. 

4. NFC transmission distance is about 20mm(transmission condition will vary,  

depend on each smartphone design and style of phone bags) 

--------------------------------------------------------------------------------------------------- 

TRANSMITTER BATTERY INSTALLMENT 

Install a CR2032 battery as back side illustrated. 

Step 1. Place O-ring 

or check if O-ring already in the interval of battery cover.

 

HRM-BLE-300     Manual      HR-08