RDI Technology Co. Ltd. NR204AD Benutzerhandbuch

 

 

INSTALLATION 

This unit is designed for installation on an automobile sun visor or under the dashboard.  Do not 
install on top of the dashboard as the sun may damage the unit.  The transmitter must be operated 
within the automobile and switch depressed only for a period of time necessary to start the 
door/gate.   

 

TROUBLESHOOTING 

Should you begin to experience loss of range, replace the 9volt battery. If your unit should fail to 
operate at all, check that the “code settings” match your receiver. 

 

MODEL EXPLANATION:

 

This receiver is used to control two single button electric operators, which are in close proximity 
or one commercial operator that has open/close capability. 
The 9-position Dipswitch can be set to match its companion transmitter, NT80G, thereby 
isolating the unit from nearby units. 
NOTE: If you are replacing a receiver or transmitter, be sure these codes match.  These units 
operate at factory set, crystal controlled wireless frequency of 433.92MHz. 
 
If you are going to use the NR204AD receiver for anything other than the Telectron garage door 
operator, note that both contacts are normally open dry contacts