Shanghai Helang Electronics Co. Ltd. HL24T2 Benutzerhandbuch

7. Balance 

weight 

8. Steering 

trim 

9. Steering 

Stick 

10. Throttle Stick 

11. Power indicator 

12. Power switch 

 

How to charge: 

Transmitter battery installation: 

Open cover—Install 4*Batteries (Check polarity)—Close cover 

 

Charging the flight battery with the transmitter: 

Open the cover—Charge Socket—Connect transmitter charge plug to socket (Match Red dot to Red dot) 

 

Charging your RoboCopter: 

The RoboCopter’s charger has unique peak detection circuitry that ensures an accurate charge every time   

and protects your battery from the dangers of over charging. During the charge cycle it continually monitors 

the battery’s charge curve and automatically stops charging when the peak/full charge is detected.     

1.Make sure the transmitter and RoboCopter power switches are turned    ‘ OFF ’ before charging.    2. Plug 

the transmitter charge lead (found in the bottom of the transmitter) into the charging port on the RoboCopter.   

Match the ‘Red Dot’ on the charging plug to the ‘Red Dot’ on the RoboCopter charge socket (see picture 

opposite).  

3. The LED indicator on the transmitter will glow ‘Solid’ when the battery is being charged and then ‘Flash’ 

when the battery is close to full. The LED will ‘Go Out’ when battery is fully charged. 

 

Lifting off for the first flight:     

1. Pull the throttle stick down to the bottom of its travel and then turn ‘ON’ the transmitter.   

2. Keeping everything clear from the rotors turn ‘ON’ the RoboCopter power switch. The rotor will pulse 

once.   

3. Place the RoboCopter on a smooth surface with the tail pointing towards you.       

4. Quickly push the throttle stick up to just over half way, the main rotor will spin up and Robocoper will 

take off. Climb meters high and hold at that height.    Remember only small, smooth movements of the 

throttle stick are required. 

 

Making Flight Adjustments - Trimming: (RoboCopter turns left or right)   

5. Once in the air if you notice that your RoboCopter wants to “ wander/turn ” to the left or right on it’s own, 

some trim adjustments may be necessary.   

 

The steering trims make small adjustments direction RoboCopter is turning.   

Turns right - Trim left. Turns left - Trim right. to RoboCopters direction. If the nose (front) turns right press 

the opposite trim to theTurns right Turns left    Trim right      Trim left Flight control: For smooth control of 

RoboCopter always make small control movements. 

 

Gaining or losing height: When your RoboCopter is stable in the air, gently push/pull the throttlestick