Pioneering Technology Inc. PTI-STTZ Benutzerhandbuch

ROUBLESHOOTING

1. The light on the base unit is on but I never get an alert when I am cooking.

Base is not responding



A power outage or fluctuation has caused the base unit to lock up. Unplug
the base. Wait 10 seconds and plug it in again.



The stove may be too far from the base unit. Move the base to an outlet
closer to the stove/range.

Dial is not transmitting



The battery in the dial may be dead. Replace battery.

The learn procedure has not been performed or the memory in the dial has
been erased.



Perform installation again.

2. Every time I perform a calibration the base unit beeps 5 times.

The RangeMinder does not recognize the stove type.



Location of HI and LO are not where expected. Repeat calibration being
careful to stop at the exact locations of HI and LO.



Stove/range type not in memory. The stove/range is not one of the common
types held in memory or it has a

dual-ring

type burner.

NOTE: Dial will default to 5 minutes in this case.

3. The base unit does not beep after I insert a new battery and place it on the

stove/range.

Dial is not responding to your touch or the magnets on the stove/range.



After  a  new  battery  is  installed  in  the  dial  the  touch  sensor  will  perform  a
self-calibration.    It  you  are  touching  the  touch-sensitive  area  during  this
process  the  calibration  will  fail  and  the  dial  will  be  unable  to  detect  your
touch.   When  installing  a  battery  do  not  touch  the  grip  portion for  a couple
seconds to allow the calibration to complete.



Ensure sensor ring is installed on the stove and the arrow is pointing toward
the OFF position (usually up).