L-3 Communications Aydin Corporation 6000-8501900 Benutzerhandbuch

Seite von 64

Zusammenfassung der Spezifikationen benutzerhandbuch für L-3 Communications Aydin Corporation 6000-8501900

  • Seite 1: The GSM Terminal
  • Seite 2: Terminal Configuration
  • Seite 3: Quick Setup Guide GSM Terminal Wireless Subscriber Unit Model 6000 User Guide
  • Seite 4 NOTICE This manual is subject to change without notice and should not be construed to be a commitment in...
  • Seite 5TABLE OF CONTENTS The GSM Terminal ............................. 1 Using the terminal 6 Introduction 1 Testing the terminal 7 Included parts...
  • Seite 6TABLE OF CONTENTS, CONTINUED Voice/fax/modem mode .......................13 Setting the Serial Port Data Rate 23 Making calls 13 CLI Protocol Selection...
  • Seite 7TABLE OF CONTENTS, CONTINUED GSM Terminal technical data ............. 29 Care of indoor antenna 52 Appendix A: Establishing a GPRS...
  • Seite 8
  • Seite 9: SIM cardTHE GSM TERMINAL connection to PC either through modem or digital serial interface. The GSM Terminal can be Congratulations on...
  • Seite 10 Terminal to one of the phone jacks in the home/ GSM TERMINAL CONFIGURATIONS office. This allows all home/office telephony...
  • Seite 11 modem phone QUICK SETUP GUIDE GSM TERMINAL This section provides you with information on how to quickly set up...
  • Seite 121. Install Antenna Figure 6. Connecting and tightening the antenna. Figure 7. Battery cover removal • Install the antenna onto...
  • Seite 13: Voice/fax/modem mode to the power supply to ensure proper operation • Using a pen or other pointed object, depress and recharging...
  • Seite 144. Connect Telephone Set 6. Check the LEDs • Connect a standard analog telephone set into • LED 1 will...
  • Seite 15 LED 1 LED 2 LED 3 • LED 2 on the Terminal indicates signal POWER SUPPLY strength. See Table...
  • Seite 16Ring Back Test - 9. Mounting the GSM Terminal on a wall • On any telephone connected to the Terminal,...
  • Seite 17SIM CARD In the case of a wrong PIN entered, LED 3 will continue blinking red and you will hear...
  • Seite 18CALL RELATED SUPPLEMENTARY SERVICES After receiving a Call Waiting indication you can put the first call on hold and accept...
  • Seite 19: Extended Servicesservice must be supported by the service provider. If GSM RELATED SUPPLEMENTARY SERVICES your service provider does not support this...
  • Seite 20SUPPLEMENTARY SERVICE TO ACTIVATE TO DEACTIVATE TO CHECK STATUS PIN Enter PIN #** <PIN> -- -- Change PIN ** 04...
  • Seite 21EMERGENCY NUMBER Voice Calls Voice calls on the GSM Terminal are made the Both ‘911’ and ‘112’ Emergency number dialing...
  • Seite 22 After completion of the fax or modem call If the SIM card has only one assigned number the GSM...
  • Seite 23modem (To configure the Terminal as a modem you Also, you may need to use the following should use standard...
  • Seite 24bearer type becomes active for the subsequent data SPEED MODEM TYPE KEY CODE calls. Autobauding none 0 1200 bps V.22...
  • Seite 25: SMS MessagingSUPPLEMENTARY SERVICE TO ACTIVATE TO DEACTIVATE TO CHECK STATUS SYSTEM INFORMATION Signal strength display #* 20 * 1 #* 20...
  • Seite 26 List all received messages #* 33 * 1 -- -- SOFTWARE VERSION DISPLAY SUPPLEMENTARY Display SERVICE SW version, date...
  • Seite 27EXTENDED SERVICES After 3 unsuccessful attempts the SIM card will be locked. To unlock it you will need to input...
  • Seite 28To enable auto PIN entry, enter the following Calling Line Identification Restriction sequence: (CLIR) #* 12 * 1 Calling Line...
  • Seite 29: GSM Terminal technical dataTo disable CLIR, enter the following sequence: Current Call Metering Services (CCM) #* 13 * 2 Current Call Metering service...
  • Seite 30Wait for the confirmation tone before placing the The following symbols are used for direction receiver on hook. information: To...
  • Seite 31: connectionWait for the confirmation tone before placing the To reset the total call timer, enter: receiver on hook. The phone...
  • Seite 32CLI Protocol Selection i Due to the limitation of ETSI DTMF standard only the phone number of the calling party...
  • Seite 33To set the system time, enter the follwing sequence: SMS COMMANDS DESCRIPTION +CMGF Message format #* 25 * YYMMDDhhmm +CMGR...
  • Seite 34The following will be returned: Set Service Center Number AT+CSCA= +CMGL:1,“REC READ”, “+336290918”, ,”99/05/01 14:19:44+04 [the second message] “12063030004” +CMGL:2,“REC...
  • Seite 35Send SMS showing the newly received SMS message index. This SMS message index number is used when AT+CMGF=1 Set text...
  • Seite 36You can control various SMS commands through your connected telephone keypad using following dialing sequences: KEY SEQUENCE DESCRIPTION #* 30...
  • Seite 37GSM TERMINAL TECHNICAL DATA GSM 850 Frequencies: TX 824-840 MHz, GSM AIR INTERFACES RX 869-896 MHz Frequency Bands: Dual-Band EGSM...
  • Seite 38TELEPHONE INTERFACES INCLUDED POWER SUPPLY Telephone: Speech AC input: 100-240 Vac; 47-63 Hz, 3-pole AC inlet Analog Fax: Group 3...
  • Seite 39 APPENDIX A Modem Installation ESTABLISHING A GPRS CONNECTION 1. Start the Control Panel program by selecting Start->Settings->Control Panel Setting...
  • Seite 40: Windows 2000 3. The GSM Terminal should be detected automatically. Click “Next >” 2. Uncheck “Don’t detect my modem; I will...
  • Seite 414. Click “Finish”. • Set “Data Bits:” combo box to “8” 5. Select “Standard Modem” installed in previous • “Parity:”...
  • Seite 42 i APN is the access point address obtained from Installing a Network Connection the service provider. For example, if the...
  • Seite 43 5. Click “Configure…” In the “General” tab, for “Port:” • select the communications port that is connected to the...
  • Seite 44 • Click “Advanced…” 7. Click “Next >” • Check the “Use flow control” checkbox. 8. Leave the Area code...
  • Seite 45A new connection has been created which should have the same connection name as in step 4. Click “Finish”. 3....
  • Seite 46 • Uncheck “Use IP header compression” 5. Click the “OK” button. 4. Select “TCP/IP Settings…”. • Select “Server assigned...
  • Seite 47Using GPRS to Connect to the Internet 5. After a GPRS connection is made (the (Windows 98) “Connection Established” window...
  • Seite 48 APPENDIX B Installing and Configuring the Modem GPRS CONNECTION ON WINDOWS 2000 1. Open the “Control Panel” by selecting...
  • Seite 493. Under the “Modems” tab, click “Add…”. 4. Select “Unknown Modem” installed in previous • Uncheck “Don’t detect my modem;...
  • Seite 50: connection6. Under the “Advanced” tab in the “Unknown Modem Properties” window: Note: If the string is too long to type...
  • Seite 51: supplementary service codes8. Click the “Advanced” tab. 9. In the “Unknown Modem Properties” window, • Set the “Data Bits:” to “8”, “Parity:”...
  • Seite 52: Safety and performance issuesInstalling and Configuring a Network Connection 1. Open the “Start” -> “Settings” -> “Network and Dial-Up Connections” icon. 3. Select...
  • Seite 534. Select “I want to set up my Internet connection manually, or I want to connect through a local area...
  • Seite 54: Regulatory Information7. Leave the Area code blank. For the telephone number, put in *99***1# and uncheck “Use area code and dialing...
  • Seite 55: Warranty Information10. If you have the required information from your service provider, you may configure the Internet Mail Account. Otherwise, choose...
  • Seite 56 13. Click the “Networking” tab. • Set “Maximum speed (bps):” field to “57600”. Under “Type of Dial-Up Server”: •...
  • Seite 57i If your GSM/GPRS provider requires Using GPRS to Connect to the Internet you to enter the IP address and...
  • Seite 58 APPENDIX C APPENDIX D TROUBLESHOOTING GPRS CONNECTION USING YOUR PC AS A FAX WINDOWS 98 AND WINDOWS 2000 Using...
  • Seite 59 21 Unconditional call forwarding 61 No replay call forwarding 62 Not reachable call forwarding APPENDIX E The 67 Network...
  • Seite 60SAFETY & PERFORMANCE ISSUES Care of Indoor Antenna • Use only an antenna specified for the Terminal. Please read this...
  • Seite 61Since the Specific Absorption Rate (SAR) Explosive Atmospheres measurement is inteded for products that are usually Do not use the...
  • Seite 62Children Children should not be allowed to play with the Terminal, as it contains small parts that could become detached...
  • Seite 63WARRANTY INFORMATION If a defect is determined by L-3 Communications Global Network Solutions to be the responsibility of L-3 Communications...
  • Seite 64 L3 communications Global Network Solutions PAGE 56 • GSM TERMINAL USER GUIDE www.gns.l-3com.com
downloadlike
ArtboardArtboardArtboard