L-3 Communications Aydin Corporation 6000-8501900 Benutzerhandbuch

P

AGE

 50 • GSM T

ERMINAL

 U

SER

 G

UIDE

WINDOWS 98 AND WINDOWS 2000

If the PC reports an error attempting to make a 

connection to the GPRS network or communicating 

with the GSM Terminal, perform the following steps 

to set the unit’s serial communication settings to the 

factory defaults:

1. Disconnect the serial cable from the GSM 

Terminal.

2. Connect the telephone to the GSM Terminal.
3. Lift the handset and dial #*22.
4. Wait for the confirmation tone and hang up.

i The factory default settings are: Autobaud, 8 

Data bits, No Parity, and 1 Stop bit

GSM Terminal can be configured as a modem to 

be used with PC based fax client software.  After 

installing GSM Terminal as a modem to your 

PC, install your favorite fax software.  During 

installation, make sure to set your modem descriptor 

to CLASS 1 (Hardware Flow Control). 

Also, you may need to change default initialization 

string assigned by your fax software to 

“AT+CSNS=2” to accept fax calls coming from 

outside of GSM network when single numbering 

scheme is used.