YEALINK NETWORK TECHNOLOGY CO. LTD. CP930W Benutzerhandbuch

1. Tap the 

OK soft key on the CP930W, and then select Register Handset.

2. Select the desired base station and then tap the 

OK soft key. 

    The CP930W begins searching the base station.
3. Tap the 

OK soft key after searching a base station successfully. 

4. Enter the base station PIN (default: 0000), and then tap the 

Done soft key to complete the 

    registration.

To register to multiple base stations, tap the 

Menu->Settings->Registration->Register Hand-

set, then repeat steps 2-4.

Note: 
•  If the CP930W is registered to the base station successfully, the LCD screen prompts  

 

    “Handset Subscribed” and “Base NO.”( the last 4 characters indicate the base station’s MAC  

   address).
•  If the CP930W LCD screen prompts “Searching for Base”, check that your base station is    

  powered on.

You can configure the base station to obtain network settings in one of the following ways:  

By default, the base station attempts to contact a DHCP server in your network to obtain the val-

id network settings, such as IP address, subnet mask, gateway address and DNS address.  

If the base station cannot contact a DHCP server for any reason, you need to configure the IP 

address, subnet mask, gateway address, primary DNS address and secondary DNS address for 

the base station manually.
To configure the network parameters for the base station manually: 
1. Tap the 

Menu->Settings->Advanced Settings (default PIN: 0000)->Network->Basic.

2. Select the desired IP addressing mode from the 

IP Mode field.

3. Select the desired IP addressing mode.
4. Make the desired changes.
5. Tap the 

Save soft key to accept the change.

Note: 

•  The DECT conference phone supports either or both IPv4 and IPv6 addressing modes, but   
    IPv6 is disabled by default.
•  Wrong network settings may result in inaccessibility of your phone and may affect the 
    network performance. Contact your system administrator for the network parameters.

5