Fluke Electronics F381 Benutzerhandbuch
Remote Display True-rms Clamp Meter
Safety
Information
3
Remove the test leads from the Meter before the battery door is opened.
Examine the test leads for damaged insulation or exposed metal. Check test lead
continuity. Replace damaged test leads before using the Meter.
continuity. Replace damaged test leads before using the Meter.
Do not use the Meter if it operates incorrectly. Protection can be compromised.
When in doubt, have the Meter serviced.
When in doubt, have the Meter serviced.
Do not use the Meter around explosive gas, vapor or in damp or wet
environments.
environments.
Use only type AAA batteries, properly installed in the Meter case, to power the
Meter.
Meter.
To avoid false readings that can lead to electrical shock and injury, replace the
batteries as soon as the low battery indicator ( or )
appears.
batteries as soon as the low battery indicator ( or )
appears.
When servicing the Meter, use only specified replacement parts. See Table 5.
Have the Meter serviced only by qualified service personnel.
Be careful around voltages > 30 V ac rms, 42 V ac peak, or 60 V dc. Such
voltages pose a shock hazard.
voltages pose a shock hazard.
Do not apply more than the rated voltage, as marked on the Meter, between the
terminals or between any terminal and earth ground.
terminals or between any terminal and earth ground.
When using the probes, keep fingers behind the finger guards on the probes.