TP-Link Technologies Co. Ltd. MW8901G Benutzerhandbuch

22

¾

DHCP Relay: Select Relay, then you will see the next screen (shown in Figure 4-11), and the 

Router will work as a DHCP Relay. A DHCP relay is a computer that forwards DHCP data 

between computers that request IP addresses and the DHCP server that assigns the 

addresses. Each of the device's interfaces can be configured as a DHCP relay. If it is enabled, 

the DHCP requests from local PCs will forward to the DHCP server runs on WAN side. To 

have this function working properly, please run on router mode only, disable the DHCP server 

on the LAN port, and make sure the routing table has the correct routing entry. 

Figure 4-11 

x

DHCP Server IP for Relay Agent: Enter the DHCP server IP Address runs on WAN 

side.

)

If you select Disabled, the DHCP function will not take effect. 

Choose “Interface Setup

ėWireless” menu, and you will see the Wireless screen (shown in 

Figure 4-12 ). Please configure the parameters for wireless according to the descriptions below.