Light-O-Rama Inc. RF02 Benutzerhandbuch
LOR-RF-V4
Page 7
buttons. The “Current Device Parameters” window
will display this information and more.
will display this information and more.
Radio Frequency (RF channel)
You can select the frequency by clicking one of the
32 frequency buttons (0 to 31). This is only required
if a nearby user has LOR transceivers or some other
device operating in the 900 MHz band is interfering
with your show. After making you selection, click the
“Update Configuration” button to change the
transceiver’s persistent memory.
32 frequency buttons (0 to 31). This is only required
if a nearby user has LOR transceivers or some other
device operating in the 900 MHz band is interfering
with your show. After making you selection, click the
“Update Configuration” button to change the
transceiver’s persistent memory.
Network Speed (RS485 link speed)
You can select the RS485 network speed by clicking
either the 19200 button or the 57600 button. After
making you selection, click the “Update
Configuration” button to change the transceiver’s
persistent memory.
either the 19200 button or the 57600 button. After
making you selection, click the “Update
Configuration” button to change the transceiver’s
persistent memory.
Transmit Power
You can select the transmitter power output by
clicking one of the “Power Level” buttons. After
making you selection, click the “Update
Configuration” button to change the transceiver’s
persistent memory.
clicking one of the “Power Level” buttons. After
making you selection, click the “Update
Configuration” button to change the transceiver’s
persistent memory.
LOR-RF-V4
Page 8
Persistent Memory
The transceiver has an EEPROM that is part of the
CPU to remember its configuration settings over
power failures. The transceiver will immediately
reboot when “Update Configuration” completes its
work. This reboot causes the transceiver to load the
new configuration from the EEPROM.
CPU to remember its configuration settings over
power failures. The transceiver will immediately
reboot when “Update Configuration” completes its
work. This reboot causes the transceiver to load the
new configuration from the EEPROM.
Important Note
If you change the RS485 network speed you must
also do this in the Sequence Editor and Show Player
if the PC is connected to a transceiver that controls
your show. Transceivers do not automatically detect
the network speed. If the PC’s or MP3 Director’s
speed does not match the transceiver, the
transceiver will not recognize and therefore not
transmit LOR commands.
also do this in the Sequence Editor and Show Player
if the PC is connected to a transceiver that controls
your show. Transceivers do not automatically detect
the network speed. If the PC’s or MP3 Director’s
speed does not match the transceiver, the
transceiver will not recognize and therefore not
transmit LOR commands.