SEA USA Inc. SMART Benutzerhandbuch
F. User’s manual
ELI
M
NA
R
PR
I
SMART COPY
TRANSMITTER TWO CHANNEL & THREE CHANNEL
Freq. 433.920 MHz
Rev. 00 , 09/2004
English
DESTINATION OF USE
The 433.920MHz SMART COPY transmitter has been planned to be used exclusively as a transmitter of digital data with a frequency of
433.920 MHz sent to a radio receiver created by SEA which transmits on the same frequency and which is codified to be interfaced with the
433.920 MHz SMART COPY transmitter. It must be used only as a generator of commands to send to a SEA s.r.l. receiver to automatize the
opening and/or closing of doors, gates and leaves and it must be supplied with safety tension (3Vdc battery CR2032 size) which will be waste
in the provided containers.
The 433.920MHz SMART COPY transmitter has been planned to be used exclusively as a transmitter of digital data with a frequency of
433.920 MHz sent to a radio receiver created by SEA which transmits on the same frequency and which is codified to be interfaced with the
433.920 MHz SMART COPY transmitter. It must be used only as a generator of commands to send to a SEA s.r.l. receiver to automatize the
opening and/or closing of doors, gates and leaves and it must be supplied with safety tension (3Vdc battery CR2032 size) which will be waste
in the provided containers.
Notice:
The useful capacity of this system (as
that of all the systems which operate with
radio frequency), can change according
to the entity of the electromagnetic
pollution and of RF false signals in the
installation site, or of probable obstacles
which are bewteen the radio transmitter
and the related receiver.
The useful capacity of this system (as
that of all the systems which operate with
radio frequency), can change according
to the entity of the electromagnetic
pollution and of RF false signals in the
installation site, or of probable obstacles
which are bewteen the radio transmitter
and the related receiver.
Technical Characteristics
Power Supply:
Power Supply:
3Vdc (battery CR2032 size)
Absorption:
20 mA max (in trasmission)
Transmitting frequency :
433.920MHz
Capacity:
100 mt
Code:
64 bit digital
N. of channels:
2 3
Working temperature:
-20°C / +55°C
Storage temperature:
-30°C / +80°C
Dimensions:
64 x 35 x 14 mm
Humidity:
from 5% to 90% not condensing
DECLARATION OF CONFORMITY
This transmitters is in conformity with the 99/5/EC directive based on the standards:
- ETS EN 301 489; ETS EN 301 489-3; ETS EN 300 220-1; ETS EN 300 220-3; EN 60950
The user of this system must follow the norms in force in the country where it si used.
This transmitters is in conformity with the 99/5/EC directive based on the standards:
- ETS EN 301 489; ETS EN 301 489-3; ETS EN 300 220-1; ETS EN 300 220-3; EN 60950
The user of this system must follow the norms in force in the country where it si used.
Quoted from Part 2.1074
Devices subject only to a Declaration of Conformity shall be uniquely identified by the responsible party. This identification shall not be of a
format which could be confused with the FCC identifier required on certified, notified, type accepted or type approved equipment. The
responsible party shall maintain adequate identification records to facilitate positive identification for each device.
Devices subject only to a Declaration of Conformity shall be uniquely identified by the responsible party. This identification shall not be of a
format which could be confused with the FCC identifier required on certified, notified, type accepted or type approved equipment. The
responsible party shall maintain adequate identification records to facilitate positive identification for each device.
Section 15.19 Labeling requirement
This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Section 15.21 Information to user.
The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. In cases where the
manual is provided only in a form other than paper, such as on a computer disk or over the Internet, the information required by this section may
be included in the manual in that alternative form, provided the user can reasonably be
expected to have the capability to access information in that form.
The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. In cases where the
manual is provided only in a form other than paper, such as on a computer disk or over the Internet, the information required by this section may
be included in the manual in that alternative form, provided the user can reasonably be
expected to have the capability to access information in that form.
NOTICE: THE MANUFACTURER CANNOT BE CONSIDERED RESPONSIBLE OF THE DAMAGES CAUSED BY PRODUCT MISUSE.
SEA reserves the right to bring proper modifications or changes to its products and/or to this manual without warning.
SERVICING
The only servicing intervention to apply to this system is the battery substitution (see fig.1),
when there is an extreme capacity reduction or when it stops working. To obtain optimum
performance it is advisable to substitute the battery every two years.
The only servicing intervention to apply to this system is the battery substitution (see fig.1),
when there is an extreme capacity reduction or when it stops working. To obtain optimum
performance it is advisable to substitute the battery every two years.
+
-
Fig. 1
Sistemi elettronici
di Aperture Porte e Cancelli
di Aperture Porte e Cancelli
SEA S.r.l.
DIREZIONE E STABILIMENTO:
Zona industriale 64020 S.ATTO Teramo - (ITALY)
Tel. 0861 588341 r.a. Fax 0861 588344
DIREZIONE E STABILIMENTO:
Zona industriale 64020 S.ATTO Teramo - (ITALY)
Tel. 0861 588341 r.a. Fax 0861 588344
http://www.seateam.com
e-mail:seacom@seateam.com