Goliath Solutions SPIDER-10-001 Benutzerhandbuch
FSM Cable Installation & MEU Activation
Page 10 of 43 Rev. 1A, Rev. Date: 8/31/2006
Use or Disclosure of this document is covered under the Non-Disclosure Agreement executed between the
prospective vendor and Goliath Solutions LLC.
3) Walk thru the Stock Room to determine the best location for one ATA (Transmitter
Antennae) and two ARA (Receiver Antennae). If the complete Pre-Install survey was done
the location is marked by a Yellow Dot for the ATA and Green Dots for the ARA.
Remember the restrictions in the stock room are the length of the cable from the MEU and
limited locations on the girders due to the conduit mounted on them. Transmitters and
Receivers should be a minimum of 8’ apart.
the location is marked by a Yellow Dot for the ATA and Green Dots for the ARA.
Remember the restrictions in the stock room are the length of the cable from the MEU and
limited locations on the girders due to the conduit mounted on them. Transmitters and
Receivers should be a minimum of 8’ apart.
4) Verify the phone number for phone line 2. ( This is the number that the MEU uses to call
out)
5) Review with the Cable Installation Vender the selected location for all of the equipment to
be installed and the location of the phone block and the MEU. If done during your walk
through this may be able to be eliminated.
through this may be able to be eliminated.
6) Verify that you have the correct equipment for the installation of this store. This means
verify that you have the correct number of ATA, ARA, and cables for this store. If not
notify the Help Desk immediately. You will have provisions in your hot spare kit but this
will need to be replenished
notify the Help Desk immediately. You will have provisions in your hot spare kit but this
will need to be replenished
7) Give the Cable Installation Vender the phone number for phone line 2. Make sure they
know they can not touch the primary phone number for the store.
Quality Assurance:
During the installation process it is your responsibility to perform the following QA tasks:
1) Verify that the work area is kept as clean as possible. Make sure that it is not a hazard to
1) Verify that the work area is kept as clean as possible. Make sure that it is not a hazard to
the Stores employees or customers.
2) Verify that the Cable Install Vender is compliant with Goliath Solutions’ and the Retailers
wiring standards.
3) Verify that work areas are cleaned up after the Cable Install Vendor is complete in that area
of the store.
4) Verify that push pins, dots and dry erase marks are removed from the ceiling or the floor of
the store and replaced with the labels provided by Goliath Solutions. Examples are found
in the Cable Installation & MEU Activation Manual.
in the Cable Installation & MEU Activation Manual.
5) Keep the Store Management informed during the install.