KING 433A Benutzerhandbuch

Page 10

Note: For automatic satellite switching, King Controls recommends using a Dish Network model 311 receiver for Dish

500, and a Dish Network model VIP211 or a VIP211k HDTV receiver for Dish HD Western Arc with Locals and
Dish HD Alternate with Locals.  Do not use dual tuner receivers or receivers with built-in recorders.

If you do not have a clear view of the satellites, the switch will not load correctly.

The SW21 and SW64 switches are a receiver software configuration that is loaded into the receiver after
running a check switch test with the dish locked on and configured for the appropriate service.  

This one time procedure will not need to be repeated after successful installation, unless a) check switch test is
run again while connected to a home dish system, b) check switch is run when the receiver is not connected, 
c) you travel outside the coverage area of your chosen satellite trio and switch trios (Dish HD Western Arc with
Locals/Dish HD Alternate), or d) you are parked in an area where the selected satellites are blocked, but are
able to select alternate satellites and get signal.

Before running the check switch, you must put the VuQube in the proper mode.

Mode 01: Normal operating mode (use without automatic satellite switching)

Mode A2: Automatic dual satellite switching (DISH 500)

Mode A3: Automatic tri-satellite switching (DISH HD Alternate with Locals and DISH HD

Western Arc with Locals)

1. Press the MODE button.

2. Scroll thru the options with the up and down arrows.  The 

large “X” shape on the right of the display will light up to
indicate which mode is active.

3. Select A2 for Dish 500, or A3 for HD Alternate or HD Western Arc.

4. Press and hold the Mode button until the segments on the display all start turning black.

When all of the segments turn black, “AUTO” will appear,and the display will return to its
normal condition, displaying the current elevation of the antenna and the direction it is
pointing.