Cradlepoint S4A525A Benutzerhandbuch
Revision 1.1
27 May 2015
SAFETY, REGULATORY, AND WARRANTY GUIDE
CRADLEPOINT AER3100
MODEL: S4A525A
CRADLEPOINT AER3150
MODEL: S4A530A
CRADLEPOINT MC400LPE
MODEL: MC400LPE
CRADLEPOINT MC400LP3
MODEL: MC400LP3
This important Product Information and Safety Guide contains safety, handling,
disposal, regulatory, trademark, copyright, and software licensing information.
Read all safety information below and operating instructions before using the
device to avoid injury.
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
following measures:
• Reorient or relocate the receiving antenna.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC STATEMENT
For product available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible.
This device is restricted for indoor use.
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 35 cm between the radiator & your body.
This device and it's antennas(s) must not be co-located or operating in
conjunction with any other antenna or transmitter except in accordance with
FCC multi-transmitter product procedures.
This device and it's antennas(s) must not be co-located or operating in
conjunction with any other antenna or transmitter except in accordance with
FCC multi-transmitter product procedures.
To comply with FCC regulations limiting both maximum RF output power and
human exposure to RF radiation, the maximum cellular antenna gain must not
exceed 3.3 dBi.
To comply with FCC regulations limiting both maximum RF output power and
human exposure to RF radiation, the maximum WiFi antenna gain must not
exceed 5dBi.
INDUSTRY CANADA STATEMENT
This device complies with Industry Canada license-exempt RSS standards.
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
INDUSTRY CANADA RADIATION EXPOSURE STATEMENT
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
INDUSTRY CANADA RADIATION EXPOSURE STATEMENT
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 45 cm between the radiator & your body.
This radio transmitter (IC: 6921A-S4A525A) has been approved by Industry
Canada to operate with the antenna types listed below with the maximum
permissible gain and required antenna impedance for each antenna type
This radio transmitter (IC: 6921A-S4A525A) has been approved by Industry
Canada to operate with the antenna types listed below with the maximum
permissible gain and required antenna impedance for each antenna type
indicated. Antenna types not included in this list, having a gain greater than
the maximum gain indicated for that type, are strictly prohibited for use with
this device.
For product available in the USA/Canada market, only channel 1~11 can be
the maximum gain indicated for that type, are strictly prohibited for use with
this device.
For product available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible.
The device for the band 5150-5250 MHz is only for indoor usage to reduce
potential for harmful interference to co-channel mobile satellite systems.
This device and it's antennas(s) must not be co-located or operating in
The device for the band 5150-5250 MHz is only for indoor usage to reduce
potential for harmful interference to co-channel mobile satellite systems.
This device and it's antennas(s) must not be co-located or operating in
conjunction with any other antenna or transmitter except in accordance with
IC multi-transmitter product procedures.
IC multi-transmitter product procedures.
These devices have been designed to operate with cellular antennas having a
maximum gain of 3.3 dBi. Antennas having a higher gain are strictly prohibited
per regulations of Industry Canada. The required antenna impedance is 50
ohms.
maximum gain of 3.3 dBi. Antennas having a higher gain are strictly prohibited
per regulations of Industry Canada. The required antenna impedance is 50
ohms.
These devices have been designed to operate with WiFi antennas having a
maximum gain of 5 dBi. Antennas having a higher gain are strictly prohibited
per regulations of Industry Canada. The required antenna impedance is 50
ohms.
maximum gain of 5 dBi. Antennas having a higher gain are strictly prohibited
per regulations of Industry Canada. The required antenna impedance is 50
ohms.
DÉCLARATION D’INDUSTRIE CANADA
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Pour les produits disponibles aux États-Unis / Canada du marché, seul le canal
1 à 11 peuvent être exploités. Sélection d'autres canaux n'est pas possible.
1 à 11 peuvent être exploités. Sélection d'autres canaux n'est pas possible.
les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés
uniquement pour une utilisation à l’intérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes
canaux.
uniquement pour une utilisation à l’intérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes
canaux.
NOTE IMPORTANTE (POUR L’UTILISATION DE DISPOSITIFS MOBILES):
DÉCLARATION D’EXPOSITION AUX RADIATIONS
Cet équipement est conforme aux limites d'exposition aux rayonnements IC
établies pour un environnement non contrôlé. Cet équipement doit être
DÉCLARATION D’EXPOSITION AUX RADIATIONS
Cet équipement est conforme aux limites d'exposition aux rayonnements IC
établies pour un environnement non contrôlé. Cet équipement doit être
installé et utilisé avec un minimum de 45 cm de distance entre la source de
rayonnement et votre corps.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement
en association avec une autre antenne ou transmetteur.
rayonnement et votre corps.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement
en association avec une autre antenne ou transmetteur.
Le présent émetteur radio (IC:6921A-S4A525A) a été approuvé par Industrie
Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant
un gain admissible maximal et l'impédance requise pour chaque type d'antenne.
Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au
gain maximal indiqué, sont strictement interdits pour l'exploitation de
l'émetteur
l'émetteur
.
INFORMATION FOR EUROPE, DECLARATION OF COMPLIANCE
Cradlepoint, Inc declares that this device is in compliance with the essential
requirements of the R&TTE Directive 1999/5/EC, Energy Related Products
Directive 2009/125/EC, Electromagnetic Compatibility Directive 2004/108/EC,
Low Voltage Directive 2006/95/EC, and RoHS2 Directive 2011/65/EU.
A copy of the original European DoC may be obtained from
Cradlepoint.com/product-certifications
Low Voltage Directive 2006/95/EC, and RoHS2 Directive 2011/65/EU.
A copy of the original European DoC may be obtained from
Cradlepoint.com/product-certifications
RF Exposure Statement: To comply with RF Exposure requirements, this
equipment should be installed and operated with minimum distance 35cm
between the radiating device and your body.
RECYCLING AND ENVIRONMENTAL INFORMATION
equipment should be installed and operated with minimum distance 35cm
between the radiating device and your body.
RECYCLING AND ENVIRONMENTAL INFORMATION
To find information on Cradlepoint’s commitment to our environment and how
to responsibly recycle or recover Cradlepoint products at the end of their
useful life, please visit Cradlepoint.com.
to responsibly recycle or recover Cradlepoint products at the end of their
useful life, please visit Cradlepoint.com.