Advanced Card Systems Limited ACR3901U-S Benutzerhandbuch
a. ACR3901U-S reader
This section introduces ACR3901U-S Reader using in Bl
info@acs.com.hk
Version 1.00
www.acs.com.hk
Page 8 of 20
2.0. Bluetooth Mode Loopback program
uetooth Mode
Tools Requirement:
b. ACOS3 Card
c. USB Cable
d. Bluetooth 4.0 USB Adaptor Dongle
e. PC & Bluetooth Mode loopback program “ACR3901U-S1_BT.exe”
Test Procedure:
1. Plug in the Bluetooth 4.0 Dongle into PC (*For the first time of use, please install the
driver, please refer to section 4.0 – Bluetooth Adaptor Driver Installation)
2. Run “ACR3901U-S1_BT_Test.exe” in folder ACR3901U-S1_TestProgram/BT_Mode/
3. If a message “Failed COM Port open” shows, press “OK” to enter program.
4. The program will be shown as the picture below. In “Com Port” selection column, select the
suitable com port and then press “Connect” to initialize the Bluetooth adaptor. “Device
initialization successfully completed!” will be shown if success. (please refer to section 4.0 to
confirm which com port should be selected)
initialization successfully completed!” will be shown if success. (please refer to section 4.0 to
confirm which com port should be selected)