Advanced Card Systems Limited EH880 Benutzerhandbuch
Document Title Here
Document Title Here
Document Title Here
eH880 and ACR880 SDE Setup Manual
Version 1.4
Page 12 of 20
info@acs.com.hk
www.acs.com.hk
Figure 3:
RJ45 Cables with Jacks Connected
4.1.3. Login
Information
The IP can be obtained by pressing <F4> key when the demo program is running
To login and access the eh880, use console (RS232, refer to 4.2) or telnet/ssh (refer to 4.1) to login
the device. (username: root, password: cdy123)
the device. (username: root, password: cdy123)
4.2. RS232
4.2.1.
Serial Port Configuration
Signal Level
RS232 (9 pin)
Baud Rate
115200 bps
Data Bit
8
Parity
None
Stop Bit
1
Flow Control
None
Connect to the device using the RS232 9 pin serial port to the female port located at the back of the
device. The male port counterpart is located at the pc. The login, if required, is till root and the
password is cdy123. Certain tools can be used to connect to the device using a serial cable;
Hyperterminal is used for Windows and Minicom for Linux.
device. The male port counterpart is located at the pc. The login, if required, is till root and the
password is cdy123. Certain tools can be used to connect to the device using a serial cable;
Hyperterminal is used for Windows and Minicom for Linux.
If you connect the RS232 cable to the PC and eh880 after the eh880 powered up, press “enter” in the
terminal window to get the login prompt.
terminal window to get the login prompt.