Winland Electronics Inc EA-WS-031108 Benutzerhandbuch

Symbols appearing on the product labeling, packaging, and/or in this manual are shown and described in Table 1.

 

Attention, consult accompanying documents or statements.

 

For product disposal, ensure the following:

• Do not dispose of this product as unsorted municipal waste.

• Collect this product separately.

• Use collection and return systems available to you.

 

Indicates product complies with RoHS-WEEE directive.

Normally Open (NO) relay contact terminal

Normally Closed (NC) relay contact terminal

Common relay contact terminal

Combined single pole double throw (SPDT) NO relay output that activates upon an 

alarm from any of the sensors.

• FCC ID: 

V5SEA800-031108

• IC: 7635A-EA800

• FCC ID: 

V5SEA-WS-031108

• IC: 7635A-EAWS

This device complies with part 15 of the FCC Rules. Operation is subject to the follow-

ing two conditions: (1) This device may not cause harmful interference, and (2) this 

device must accept any interference received, including interference that may cause 

undesired operation.
Caution Statement (per CFR 15.21):
Changes or modifications not expressly approved by the party responsible for compli-

ance could void the user’s authority to operate the equipment.
Class B Product Compliance Statement (per CFR 15.105(b)):
NOTE: This equipment has been tested and found to comply with the limits for a 

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are 

designed to provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate radio frequency energy 

and, if not installed and used in accordance with the instruction, may cause harmful 

interference to radio communications. However, there is no guarantee that interfer-

ence will not occur in a particular installation. If this equipment does cause harmful 

interference to radio or television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the interference by one 

or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

 

The TÜV certification combines electrical safety certification for Canada (SCC), United 

States (NRTL), and Europe (EU Directives). This product was voluntarily tested 

according to the relevant safety requirements and mentioned properties pertaining to 

this certification mark.

 

The product is in conformity with all applicable requirements for its placing on the 

European Union market.