Texas Instruments TINAVWC Benutzerhandbuch
6
The TI-Nspire™ cradle charging bay can hold from one to five wireless
cradles. After you place the cradles in the charging bay, they are charged
simultaneously until all are fully charged. If the batteries are fully
discharged, it may take up to 12 hours to fully charge the batteries.
cradles. After you place the cradles in the charging bay, they are charged
simultaneously until all are fully charged. If the batteries are fully
discharged, it may take up to 12 hours to fully charge the batteries.
With five wireless cradles in the charging bay, you should charge them
for 12 hours. Typically this is done overnight or over a weekend.
for 12 hours. Typically this is done overnight or over a weekend.
When
the wireless cradles are fully charged in the bay, the LED shows solid
green.
green.
Note: You cannot damage the batteries by leaving them in the charging
bay beyond the time needed to fully charge them. Also, it is not
necessary to fully discharge the batteries before recharging them.
bay beyond the time needed to fully charge them. Also, it is not
necessary to fully discharge the batteries before recharging them.
1.
Make sure you have enough (3–4) power outlets for the equipment
you received. If necessary, obtain a plug strip so that you have plenty
of grounded outlets.
you received. If necessary, obtain a plug strip so that you have plenty
of grounded outlets.
2.
Insert the small end of the AC9940 power adapter cord into the
charging bay’s power jack.
charging bay’s power jack.
3.
Plug the other end of the adapter into a power outlet.
4.
Insert each TI-Nspire™ Navigator™ wireless cradle into the TI-Nspire
cradle charging bay. You can insert them only one way.
cradle charging bay. You can insert them only one way.
Note: If you purchased the individual kit and do not have a cradle
charging bay, you can charge a single wireless cradle using the AC9930
adapter instead.
charging bay, you can charge a single wireless cradle using the AC9930
adapter instead.