Ezurio Ltd 410B Benutzerhandbuch
1.1.1
FCC and Industry Canada Statements
The user manual must show the following statements:
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
could void the user's authority to operate the equipment.
To comply with the FCC RF exposure compliance requirements, this device and its antenna must not be
co-located or operating to conjunction with any other antenna or transmitter.
co-located or operating to conjunction with any other antenna or transmitter.
Considerations for OEM integration:
To inherit the modular approval, the antennas for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter.
provide a separation distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter.
This module was approved with the following antenna:
RF Solutions: ANT-24G-WHJ-SMA 0dBi
Operation of this module with any other antenna will require additional testing to be
performed.
performed.
Co-location with other radio transmitting devices operating concurrently in the same band
will require additional testing and certification.
will require additional testing and certification.
Designers should note the distinction that the FCC makes regarding portable and mobile
devices. Mobile devices are defined as products that are not used closer than 20cm to the
human body, whereas portable devices can be used closer that 20cm to the body. In the
case where the BTM521 module is used in a portable device, additional SAR testing must
be performed on the complete product.
devices. Mobile devices are defined as products that are not used closer than 20cm to the
human body, whereas portable devices can be used closer that 20cm to the body. In the
case where the BTM521 module is used in a portable device, additional SAR testing must
be performed on the complete product.
1.1.1.1
FCC Labelling requirement
If the FCC ID is not visible when the module is installed inside another device, then the
outside of the device into which the module is installed must also display a label referring
to the enclosed module. This exterior label can use wording such as the following:
“Contains Transmitter Module FCC ID: PI4410B” or “Contains FCC ID: PI4410B.” Any
similar wording that expresses the same meaning may be used.
outside of the device into which the module is installed must also display a label referring
to the enclosed module. This exterior label can use wording such as the following:
“Contains Transmitter Module FCC ID: PI4410B” or “Contains FCC ID: PI4410B.” Any
similar wording that expresses the same meaning may be used.