Wavenet Technology Pty Ltd. BM3800D Benutzerhandbuch
Appendix A - NCL INTERFACE _______________________________ Boomer-III User Manual & Integrator’s Guide
Copyright Wavenet Technology © October 2003
80
BM310012WT04
Appendix A - NCL Interface
The Boomer-III is compliant to Native Control Language (NCL) 1.2.
Wavenet Vendor-specific extensions are also listed here.
Wavenet Vendor-specific extensions are also listed here.
The specification for the NCL protocol may be obtained in Adobe
Acrobat format from the Motorola website at
Acrobat format from the Motorola website at
Generic NCL (Native Mode)
Command SDUs (CMND, ASCII A)
Commands
Value
Parameters
Value
Sub-values and Descriptions
SEND
ASCII 1
Send message.
READ_MSG
ASCII 2
Read queued message in RPM. True only if confirmed delivery mode
enabled.
enabled.
CTL_EVENT
ASCII 3
Event Report SDUs.
Control event.
GET_STATUS
ASCII 4
Get RPM status/configuration.
R_CONFIG_BLOCK
ASCII A
Get RPM configuration block.
R_RF_BLOCK
ASCII
A
Vendor-specific: Get RF status block.
R_STATUS_BLOCK
ASCII B
Get RPM status block.
R_PROD_ID
ASCII
C
Get RPM product ID:
RF_RDLAP_9.6
RF protocol is RD-LAP 9600.
ASCII 0
RF_RDLAP_19.2
RF protocol is RD-LAP 9200.
ASCII 1
RF_MDC4800
RF protocol is MDC 4800.
ASCII 2
RF_DUAL
Dual RD-LAP 9.2/MDC4800. ASCII
3
NCL_PRE1.2
NCL support is R1.0 or R1.1.
ASCII 0
NCL_1.2
NCL support is R1.2.
ASCII 2
R_SYSID
ASCII
C
Vendor-specific: Get system ID of current RF system.
R_SW_VERSION
ASCII D
Get software version number.
R_RPM_ID
ASCII E
Get RPM address.
R_RF_BLOCK_SHORT
ASCII E
Vendor-specific: Get short form of RF status block.
ASCII
F
Reserved.
R_MAX_DATA_SIZE
ASCII G
Get SDU data limit.
R_RPM_GID
ASCII H
Get RPM group IDs.
R_WAN_TYPE
ASCII I
Get WAN Type Code.
R_RF_VERSION
ASCII J
Get RF protocol version number.
R_VENDOR_ID
ASCII K
Get vendor information: VEND_MOTOROLA Vendor is Motorola
ASCII 0
ASCII 0
ASCII
L..Z
L..Z
Reserved.
R_RCV_MODE
ASCII a
Get mode of notification to the DTE for received SDUs.
R_RX_STATUS
ASCII b
Get receiver enable status.
R_TX_STATUS
ASCII c
Get transmitter enable status.
R_ANTENNA
ASCII d
Get antenna selection status.
R_RADIO_IN_RANGE
ASCII e
Get radio in range status.