Acrox Technologies Co. Ltd. MPH0050708 Benutzerhandbuch
3
Setup the connection Rf channel between the Mouse and
the Receiver
the Receiver
1.
Press the ID Switch button on the Mouse
2.
Press the ID Switch button on the bottom of the Receiver
If the mouse cursor does not move after 30 seconds, do above steps
again.
Caution: If you had completed the connection successfully, The LED on
the receiver will be flash several times. If the ID Setting is not properly,
please re set your ID again by following the above steps. Please
re-setup the Rf channel since you replace batteries
the receiver will be flash several times. If the ID Setting is not properly,
please re set your ID again by following the above steps. Please
re-setup the Rf channel since you replace batteries
Push 1
Push 2