Interepoch Technology Inc. IWE3000T Benutzerhandbuch
Password. For gaining rights to change the settings of the DRBAP.
Firmware Tools. For upgrading the firmware of the DRBAP, backing up and restoring
configuration, and configuration reset settings of the DRBAP.
configuration, and configuration reset settings of the DRBAP.
TCP/IP. TCP/IP-related settings.
Addressing. IP address settings for the DRBAP to work with TCP/IP.
DHCP Server. Settings for the DHCP (Dynamic Host Configuration Protocol) server on
the DRBAP.
the DRBAP.
IEEE 802.11. IEEE 802.11g-related settings.
Communications. Basic settings for the IEEE 802.11g interfaces of the DRBAP.
Security. Security settings for authenticating wireless users and encrypting wireless data
for an AP interface. And security settings for encrypting data transmitted over the WDS
links for a LAN-to-LAN bridge interface.
for an AP interface. And security settings for encrypting data transmitted over the WDS
links for a LAN-to-LAN bridge interface.
IEEE 802.1x/RADIUS. IEEE 802.1x Port-Based Network Access Control and RADIUS
(Remote Authentication Dial-In User Service) settings for an AP interface.
(Remote Authentication Dial-In User Service) settings for an AP interface.
Advanced. Advanced settings of the DRBAP.
Packet Filters. Ethernet Type Filters, IP Protocol Filters, and TCP/UDP Port Filters set-
tings.
tings.
Management. UPnP, System Log, and SNMP settings.
3.1.2. Save, Save & Restart, and Cancel Commands
Fig. 19. Save, Save & Restart, and Cancel.
At the bottom of each page that contains settings you can configure, there are up to three but-
tons—Save, Save & Restart, and Cancel. Clicking Save stores the settings changes to the memory of
the DRBAP and brings you back to the start page. Clicking Save & Restart stores the settings
changes to the memory of the DRBAP and restarts the DRBAP immediately for the settings changes
to take effect. Clicking Cancel discards any settings changes and brings you back to the start page.
tons—Save, Save & Restart, and Cancel. Clicking Save stores the settings changes to the memory of
the DRBAP and brings you back to the start page. Clicking Save & Restart stores the settings
changes to the memory of the DRBAP and restarts the DRBAP immediately for the settings changes
to take effect. Clicking Cancel discards any settings changes and brings you back to the start page.
If you click Save, the start page will reflect the fact that the configuration settings have been changed
by showing two buttons—Restart and Cancel. In addition, changes are highlighted in
by showing two buttons—Restart and Cancel. In addition, changes are highlighted in
red
. Clicking
Cancel discards all the changes. Clicking Restart restarts the DRBAP for the settings changes to take
effect.
effect.
17