Noah Technologies Inc INTELLISENSOR Benutzerhandbuch
Reset instructions for the INTELLI-SENSOR
If your water was shut off automatically by the Intelli-Sensor system, follow these steps
to reset the system and restore the water flow.
Turn OFF your main water line, turn the valve handle 90 degrees to the pipe.
Locate the white sensor in your home that is beeping. Pick it up and dry it until it stops
beeping. Temporarily put it somewhere dry.
Return to the shut-off room and push and hold the red button on the black receiver box
for about three second until the flashing red light dims. This will reset the receiver unit
and stop it beeping.
Contact a plumber.
Do not turn your water ON until the leak is fixed or isolated.
Instructions to restore the water supply
Do not restore the water supply until the plumbing repair has been completed or the fault
has been isolated by closing a local appliance valve.
Press down and hold the toggle switch on the receiver to the open position until the valve
motor stops running.
Release the switch
Open a faucet in your home. SLOWLY open the main water valve to a half open
position, wait fifteen to twenty seconds then SLOWLY open the valve fully.
Your system is now back to normal operation.
“This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by Noah
Technologies Inc could void the user’s authority to operate the
equipment.