Wistron Corporation LPM Benutzerhandbuch
LPM WLAN MiniCard
2011/08/10
FCC compliance Statement
Federal Communication Commission interference state-ment this equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference in a residential instal-lation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interfer-ence will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television recep-tion, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of
the following measures:
with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference in a residential instal-lation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interfer-ence will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television recep-tion, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of
the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, includ-ing interference that may cause undesired operation.
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance
could void your
could void your
authority to operate the equipment.
RF exposure warning: The equipment complies with RF exposure limits set forth for an uncontrolled environment.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
transmitter.