Wistron Corporation TP00045A1IT Benutzerhandbuch
If you still encounter the same problem after you restart your tablet, reset your tablet and restart it again,
you can perform a factory data reset operation. For more information, refer to “Resetting your tablet to
the factory default settings” on page 37.
you can perform a factory data reset operation. For more information, refer to “Resetting your tablet to
the factory default settings” on page 37.
Error messages
Message: 0177: Bad SVP data, stop POST task.
Solution: Checksum of the supervisor password in the EEPROM is not correct. The system board should
be replaced. Have the tablet serviced.
be replaced. Have the tablet serviced.
Message: 0183: Bad CRC of Security Settings in EFI Variable. Enter ThinkPad Setup.
Solution: Checksum of the Security settings in the EFI Variable is not correct. Enter ThinkPad Setup to
check Security settings, and restart the system. If you still have a problem, have the tablet serviced.
check Security settings, and restart the system. If you still have a problem, have the tablet serviced.
Message: 0187: EAIA data access error
Solution: The access to EEPROM is failed. Have the tablet serviced.
Message: 0188: Invalid RFID Serialization Information Area.
Solution: The EEPROM checksum is not correct (block # 0 and 1). The system board should be replaced,
and the box serial number needs to be reinstalled. Have the tablet serviced.
and the box serial number needs to be reinstalled. Have the tablet serviced.
Message: 0189: Invalid RFID configuration information area
Solution: The EEPROM checksum is not correct (block # 4 and 5). The system board should be replaced,
and the UUID needs to be reinstalled. Have the tablet serviced.
and the UUID needs to be reinstalled. Have the tablet serviced.
Message: 0190: Critical low-battery error
Solution: The tablet turned off, because the battery is low. Connect the ac power adapter to the tablet
and charge the battery.
and charge the battery.
Message: 0191: System Security - Invalid remote change requested.
Solution: The system configuration change has failed. Confirm the operation and try again. To clear the
error, enter the ThinkPad Setup.
error, enter the ThinkPad Setup.
Message: 0199: System Security - Security password retry count exceeded.
Solution: This message is displayed if you enter a wrong supervisor password more than three times.
Confirm the supervisor password and try again. To clear the error, enter the ThinkPad Setup.
Confirm the supervisor password and try again. To clear the error, enter the ThinkPad Setup.
Message: 2200: Machine Type and Serial Number are invalid.
Solution: Machine Type and Serial Number are invalid. Have the tablet serviced.
Message: 2201: Machine UUID is invalid.
Solution: Machine UUID is invalid. Have the tablet serviced.
Chapter 8
.
Troubleshooting problems
57