Wilson Electronics LLC 272570 Benutzerhandbuch

AIG #110996_Rev6_08 .23 .12

3301 East Deseret Drive, St . George, UT 84790

For additional Technical Support visit  www .WilsonElectronics .com 

or email at: tech@wilsonelectronics .com

Phone: 866-294-1660    Local: 435-673-5021    Fax: 435-656-2432

www .twitter .com/WilsonCellular      www .facebook .com/WilsonCellular

272570

Antenna connectors

N-Female

Antenna impedance

50 ohms

Dimensions

5 .7 x 4 .2 x 1 .5 inch (14 .0 x 10 .8 x 3 .9 cm)

Weight

1 .27 lbs (0 .544 kg)

Frequency

698-746 MHz

(Typical / Maximum)

(Typical / Maximum)

71 dB / 78 dB 

68 dB / 75 dB

(Typical / Maximum)

18 MHz / 20 MHz

Power output for single cell phone (dBm)

EVDO

29 .3

25 .5

HSPA

28 .0

24 .9

LTE

29 .2

25 .5

EDGE

28 .5

23 .8

Noise Figure (typical downlink/uplink)

3 .5 dB nominal / 5 dB nominal

Isolation

> 90 dB

110-240 V AC, 50-60 Hz, 10 W

 Notes:

     1 . Nominal gain is the maximum gain at any frequency in the passband .

     2 . Nominal bandwidth is the difference between two frequencies that are adjacent to the passband where the amplification is 20 dB lower than the passband     

         amplification .  One of the frequencies is lower than the passband and the other is higher .

     3 . The Manufacturer’s rated output power of this equipment is for single carrier operation .  For situations when multiple carrier signals are present, the rating  

         would have to be reduced by 3 .5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users .  This power  

         reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device .

     4 . The maximum power for 2 or more simultaneous signals will be reduced by 6 dB every time the number of signals is doubled .