Wilson Electronics LLC 274106SB Benutzerhandbuch

274106

Connectors

N-Female 50 ohms

Impedance (input/output)

50 Ohms

Dimensions

4.5 x 3.5 x 1.25 inch (11.4 x 8.9 x 3.2 cm)

Weight

1.5 lbs (0.7 kg)

Frequency

896-940 MHz

70 dB Maximum

Uplink/Downlink

45 MHz / 46 MHz Maximum

iDEN

+20.9 dBm

Number of 

cell phones

4

Maximum Power

2

+22.1 dBm

3

+18.6 dBm

4

+16.1 dBm

5

+14.1 dBm

6

+12.6 dBm

iDEN

+19.8 dBm

4

Maximum Power

The maximum power is reduced by the 
number of channels:

Number of 

cell phones

2

+22.9 dBm

3

+19.4 dBm

4

+16.9 dBm

5

+14.9 dBm

6

+13.4 dBm

Noise Figure (typical)

3 - 4 dB

Isolation (uplink/downlink)

>90 dB

120 V AC, 0.2 A

FCC ID:

PWO274106SB

IC:

4726A-274106SB

Notes:
1. Nominal gain is the maximum gain at any frequency in the passband.
2. Nominal bandwidth is the difference between two frequencies that are adjacent to the passband where the amplifi cation is 20 dB 

lower than the passband amplifi cation.  One of the frequencies is lower than the passband and the other is higher.

3. The Manufacturer’s rated output power of this equipment is for single carrier operation.  For situations when multiple carrier 

signals are present, the rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can 
cause interference to adjacent band users.  This power reduction is to be by means of input power or gain reduction and not by 
an attenuator at the output of the device.

4. The maximum power for 2 or more simultaneous signals will be reduced by 6 dB every time the number of signals is doubled.

3301 East Deseret Drive, St. George UT 84790

For additional Technical Support visit

www.wilsonelectronics.com

Phone: 866-294-1660        Fax: 435-656-2432

Part #000000 AIG IB900i 006 / 05.23.07