Wilson Electronics LLC 275165 Benutzerhandbuch

Seite von 16
11
12
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660   
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
Warnings and Recommendations
 Warning:  The Directional Antenna must always be located so the 
back or side points to the Inside Antenna . Never point the 
front of the Outside Antenna toward the Inside Antenna – 
this is to prevent oscillation .
 Warning:  Connecting the Signal Booster directly to the cell phone with 
use of an adapter will damage the cell phone .
 Warning:  Use only the power supply provided . Use of a non-Wilson 
Electronics product may damage your equipment .
 Warning: 
RF Safety:  All Inside Antennas used with this Signal 
Booster may not have gain (less cable loss) that exceeds 9 
dBi and must be located at least 8 inches from all people . 
Outside Antennas may not have gain (less cable loss) that 
exceeds 15 dBi and must be located at least 23 inches 
from all people . All antennas shown on page 1 meet these 
requirements .
 Warning:  Verify that both the Outside Antenna and the Inside 
Antenna are connected to the Signal Booster before 
powering up the Signal Booster .
Recommendation:  Lightning Surge Protection is recommended   
        for all in-building installations.
will not be able to get maximum gain from the booster .
*Note:  If the antennas cannot be sufficiently separated, the booster will  
 
have to operate with reduced performance by decreasing the    
 
Gain until a green light is obtained.
4. SOLID GREEN
The indicator lights on the Signal Booster will be a solid green after 
the first 15 minute installation period, if the unit is powered up and 
working properly . 
This device complies with Part 15 of FCC rules . Operation is subject to two 
conditions: (1) This device may not cause harmful interference, and (2) this 
device must accept any interference received, including interference that 
may cause undesired operation . Changes or modifications not expressly 
approved by Wilson Electronics could void the authority to operate this 
equipment .