Wilson Electronics LLC 2B3425 Benutzerhandbuch
3
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Mon.- Fri. Hours: 7 am to 6 pm MST.
4
2. Attach the Mounting Bracket
(included in this package)
a . Clean the area where the bracket is to be mounted with the supplied alcohol wipe . Allow to dry .
b . Peel the backing to expose the adhesive and press the bracket onto the desired location in the
b . Peel the backing to expose the adhesive and press the bracket onto the desired location in the
vehicle .
Note: Be sure the tab is positioned vertically, not horizontally.
c .
Allow the adhesive to cure for 24 hours before you attach the Sleek 4G .
3. Attach the Sleek
®
4G to the Bracket
Once you have installed the bracket in the desired location, and waited 24 hours for adhesive to cure, at-
tach the Sleek 4G by aligning the rectangular hole on its back with the tab on the mount bracket, grasping
the sides of the Sleek 4G, and sliding it downward approximately ¼ inch into place . You can adjust the
angle of the adhesive bracket by applying gentle pressure to the top or bottom of the Sleek 4G . The
bracket is designed to swivel when the knurled nut is loosened for greater adjustability of the Sleek 4G
viewing angle . To lock bracket into position, tighten large nut .
Connect the mini-USB plug on the power supply cable to the
mini-USB port located on the bottom of the Sleek 4G (refer to
Figure 1) and insert the vehicle power adapter into the power
socket of your vehicle .
The switch located on the right hand side of the Sleek 4G should
The switch located on the right hand side of the Sleek 4G should
be set to the desired position .
Up Position: Is for Verizon LTE .
Down Position: is for AT&T LTE (refer to Figure 2) .
The Sleek 4G may remain on all the time . However, leaving the
The Sleek 4G may remain on all the time . However, leaving the
Sleek 4G on in a vehicle when it is not running can discharge the
battery in a day or two .
NOTE: Make sure the Outside Antenna cable is connected
before powering up the Sleek.
NOTE: The 12V DC power source on many vehicles is shut
off with the ignition key.
IMPORTANT: Use only the supplied Wilson Electronics
power supply.
4. Attach the Outside Antenna cable to the Sleek
®
4G
Attach the cable from the Outside Antenna to the antenna connector on the Sleek (see Figure 1) .
multiple arm slots
for custom fit
Sleek 4G Top View
Sleek 4G Bottom View
Sleek 4G Side View
Sleek Arm
Accessory USB Power Port
Antenna Connection
Mini-USB Power Port
Selectable Switch
Up Position – Verizon
Down Position – AT&T
Sleek Arm
multiple arm slots
for custom fit
Sleek 4G Top View
Sleek 4G Bottom View
Sleek 4G Side View
Sleek Arm
Accessory USB Power Port
Antenna Connection
Mini-USB Power Port
Selectable Switch
Up Position – Verizon
Down Position – AT&T
Sleek Arm
Figure 1
Figure 2
Power up the Wilson Electronics Sleek
®
4G